The detectable warning shall extend the full width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum...
Search Results "Counter Depth"
Commonly Searched Documents
-
Curb Ramps at Marked Crossings and Vehicular Lanes
-
Benches
Benches must have seats that are a minimum of 20 inches to a maximum of 24 inches in depth and 42 inches minimum in length....
-
307 Protruding Objects
., higher than 27 inches from the floor) and below the standard head room clearance (80 inches), are limited to a 4 inch depth....
-
Summary
Summary The following report provides a brief analysis of four anthropometric dimensions which were considered relevant to the width and depth dimensions of a seating surface for wheeled...
-
711.3.2 Membrane penetrations
By a horizontal distance of not less than the depth of the wall cavity where the wall cavity is filled with cellulose loose-fill or mineral fiber insulation; 1.3....
-
Typical Issues
Access aisle depth is at least 5 feet. 2. Access aisle length is at least 20 feet. 3....
-
Clearance in Base (M301.4.1 and M302.4.1)
Where the width of the examination surface is less than 36 inches, the clearance depth would be required to extend the full width of the equipment....
- AquaTrek2 ADA Ladder System
- Assisted Living Directory - Missouri Assisted Living Facilities & Senior Care
- Bobrick Recessed Toilet Tissue Dispensers B-697
- Bobrick Recessed Toilet Tissue Dispensers B-6977
- Bobrick Semi-Recessed Paper Towel Dispenser and Waste Receptacle B-38032
- Georgia-Pacific® Manual Soap, Sanitizer & Dispensers
- McGuire Associates Disability Evacuation Plan (DEP)
-
c. Transfer Surface Size for Diagnostic Equipment Used by Patients in the Supine, Prone, or Side-lying Position
Commenter recommendations for transfer surface width ranged from 24 inches to 36 inches, while no commenters addressed the proposed depth of 15 inches....
-
2.0 Methodology
Knee Clearance Height (KCH), Knee Clearance Depth – Upper (KCDU), Knee Clearance Depth – Lower (KCDL) and Extended Depth (ED)....
-
20. DESIGN AND CONSTRUCTION STANDARDS
., signage, front desk counter) for any Brand, it shall ensure that such designs comply with the ADA Standards....
-
MAKING THE BUILT ENVIRONMENT ACCESSIBLE
no access aisle to allow deployment of a van’s wheelchair lift, steps at a facility’s entrance or within its serving or selling space, aisles too narrow to accommodate mobility devices, counters...
-
205.1 General
Where two or more outlets are provided in a kitchen above a length of counter top that is uninterrupted by a sink or appliance, one outlet shall not be required to comply with 309. 4....
-
Common Requirements (R304.5) (Section-by-Section Analysis)
A maximum counter slope of 5 percent is specified for the gutter or street at the foot of curb ramp runs, blended transitions, and turning spaces....
-
5.3.3.1 Transfer Sides Recommendation for Exam Chairs with Fixed Footrests
The Committee recommends exam chairs with a fixed footrest have a transfer surface minimum of a 17 inch depth and a 21 inch width located on both sides of the chair to allow for a left or...
- GE® 30" Slide-In Electric Convection Range JS750EFES
- Mockett TLEL3 Electrically Driven Adjustable Table Legs