Landings subject to wet conditions shall be designed to prevent the accumulation of water.
Search Results "Curb Ramp Surface"
-
11B-405.10 Wet conditions
-
General: ADA Standard Section 902.1
Dining surfaces and work surfaces shall comply with 902.2 and 902.3. EXCEPTION: Dining surfaces and work surfaces for children’s use shall be permitted to comply with 902.4....
-
Cargill, Incorporated SafeLane® Surface Overlay CA-48
SafeLane® Surface Overlay CA-48 Commercial contractors, property managers and other private winter maintenance service providers require the same anti-skid, anti-icing and infrastructure...
-
11B-1008.2.5.3.1 Handrail gripping surfaces
Handrail gripping surfaces with a circular cross section shall have an outside diameter of 0.95 inch (24 mm) minimum and 1.55 inches (39 mm) maximum....
-
11B-1008.2.5.3.1 Handrail gripping surfaces
Handrail gripping surfaces with a circular cross section shall have an outside diameter of 0.95 inch (24 mm) minimum and 1.55 inches (39 mm) maximum....
-
Scoping [4.1.2(4), 4.1.3(3)]
Requirements in 4.5 apply to accessible routes and spaces, including ramps, elevators, platform lifts, and clear floor space....
-
Sec.36.304(e) Portable ramps
(e) Portable ramps. Portable ramps should be used to comply with this section only when installation of a permanent ramp is not readily achievable....
-
Aluminum Flush Top SGF Series Pressure-Locked Grating
This series offers a type of pressure locked grating in which the cross bars are in the same plane relative to the top surface of the grating....
-
Surface
The top layer of ground on a recreation site, ORAR, trail, or beach access route.
-
§ 38.23(c)(7) Stowage
A compartment, securement system, or other appropriate method shall be provided to ensure that stowed ramps, including portable ramps stowed in the passenger area, do not impinge on a passenger's...
-
Figure 505.4 Handrail Height – Drawing from the U.S. Access Board
-
405.8 Handrails
Ramp runs with a rise greater than 6 inches (150 mm) shall have handrails complying with 505....
-
405.8 Handrails
Ramp runs with a rise greater than 6 inches (150 mm) shall have handrails complying with 505....
-
405.8 Handrails
Ramp runs with a rise greater than 6 inches (150 mm) shall have handrails complying with 505....
-
226 and 902 Dining Surfaces and Work Surfaces
226 and 902 Dining Surfaces and Work Surfaces Section 226.1 of the 2010 Standards require that where dining surfaces are provided for the consumption of food or drink, at least five...
-
§ 38.159(c)(5) Slope
If the height of the vehicle floor from which the ramp is deployed is 3 inches (75 mm) or less above a 6 inch (150 mm) curb, a maximum slope of 1:4 is permitted; if the height of the vehicle...
-
Accessible Exterior Surfaces Technical Article
Accessible Exterior Surfaces Technical Article Submitted by: Peter W. Axelson, M.S.M.E., A.T.P. Project Director Denise Chesney, M.E.B.M.E....
-
T402 Ramps and Bridgeplates
[See subsections ...]
-
§ 38.159(c) Vehicle ramp
(c) Vehicle ramp—...
-
11B-410.2 Floor surfaces
Floor surfaces in platform lifts shall comply with Sections 11B-302 and 11B-303....
-
11B-410.2 Floor surfaces
Floor surfaces in platform lifts shall comply with Sections 11B-302 and 11B-303....
-
11B-410.2 Floor surfaces
Floor surfaces in platform lifts shall comply with Sections 11B-302 and 11B-303....
-
Stable
A surface is not permanently affected by expected weather conditions and can sustain normal wear and tear from the expected use(s) of the area, between planned maintenance....
