Raised crossings, where provided, eliminate the need for curb ramps while serving to reduce traffic speeds....
Search Results "High Speed Rail"
-
Raised Crossings
-
§ 37.107(c)
(c) Compliance with paragraph (b) of this section is not required to the extent that it would significantly alter the historic or antiquated character of a historic or antiquated rail passenger...
-
Thresholds: ADA Standard Section 404.2.5
Section 404.2.5 covers the current ADA Standards for thresholds at doors.
-
Handrails Along Walking Surfaces [§403.6, §505]
Handrails along Walking Surfaces 34” – 38” high measured to the top of the gripping surface....
-
Simplified Building Concepts ADA Handrail
These components make the ADA railing easy to install....
-
Hill-Rom Likorall™ Overhead Lift, Traverse with Upright Supports
Video shows animation of how the Likorall™ Overhead Lift with Traverse Rail with upright supports is assembled and used....
-
§ 37.47(b)(2)
(2) Transfer stations on a rail line or between rail lines;...
-
§ 37.51(b)(2)
(2) Transfer stations on a rail line or between rail lines;...
-
§ 37.35(a)
(a) Transportation service provided by bus or other vehicle by an intercity commuter or rail operator, as an extension of or supplement to its rail service, and which connects an intercity...
-
Edge Protection
Edge Protection Where railings, guards, or handrails are provided, edge protection must be provided and extend a minimum of 2 inches above the ground or deck surface....
-
Safety
GSA requires users to operate their Segway at a speed no greater than a walking pace of three (3) miles per hour. ...
-
Accessible Route
requirement that where elevators or wheelchair lifts are provided on an accessible route to wheelchair spaces or designated aisle seats, they shall be provided in "such number, capacity, and speed...
-
11B-504.2 Treads and risers
Risers shall be 4 inches (102 mm) high minimum and 7 inches (178 mm) high maximum. Treads shall be 11 inches (279 mm) deep minimum. ...
-
11B-504.2 Treads and risers
Risers shall be 4 inches (102 mm) high minimum and 7 inches (178 mm) high maximum. Treads shall be 11 inches (279 mm) deep minimum. ...
-
§ 37.87(d)(1)
(1) By having and implementing, in its agreement with any intercity railroad or commuter authority that serves as a source of used intercity or commuter rail cars for a lease of seven days...
-
American Dryer, Inc eXtremeAir eXt Hand Dryer
The eXtremeAir eXt high-speed hand dryer with ECO no heat technology is the most efficient, environmentally-friendly ever!...
-
Public Entity
other instrumentality of a State or States or local government; and (3) The National Railroad Passenger Corporation, and any commuter authority (as defined in section 103(8) of the Rail...
-
6. TO USE THE PHONE I WILL NEED:
TO USE THE PHONE I WILL NEED:* TTY Cordless Large buttons Speaker phone - hands free phone Speed dialing Amplified volume and loud ringer...
-
Priority 1: Approach & Entrance
Word Fillable Form (1.5MB) Word Non-Fillable Form (1.3MB) PDF Non-Fillable Form (0.8MB)
-
§ 37.87(d)(2)
(2) By documenting that, when there is more than one source of intercity or commuter rail cars for a lease of seven days or less, the lessee has obtained all available accessible intercity...
-
11B-404.2.5 Thresholds
Thresholds, if provided at doorways, shall be ½ inch (12.7 mm) high maximum. Raised thresholds and changes in level at doorways shall comply with Sections 11B-302 and 11B-303....
-
11B-404.2.5 Thresholds
Thresholds, if provided at doorways, shall be ½ inch (12.7 mm) high maximum. Raised thresholds and changes in level at doorways shall comply with Sections 11B-302 and 11B-303....
-
11B-904.4.1 Parallel approach
A portion of the counter surface that is 36 inches (914 mm) long minimum and 34 inches (864 mm) high maximum above the finish floor shall be provided....
-
11B-904.4.1 Parallel approach
A portion of the counter surface that is 36 inches (914 mm) long minimum and 34 inches (864 mm) high maximum above the finish floor shall be provided....
