Rest one end of the level at the highest point of the sloped surface and lift the other end (see below) until the bubble is in the middle of the tube. This is the “level” position....
Search Results "Head End Wall"
Filters
Commonly Searched Documents
-
1. Sloped Surfaces
-
11B-104.1.1 Construction and manufacturing tolerances
All dimensions are subject to conventional industry tolerances except where the requirement is stated as a range with specific minimum and maximum end points....
-
408.4.6 Car Controls
Control panels shall be centered on a side wall....
-
408.4.6 Car Controls
Control panels shall be centered on a side wall....
-
704.2.2 Types III, IV and V construction
Projections from walls of Type III, IV or V construction shall be of any approved material....
-
11B-411.4.10 Support rail
Support rails complying with Section 11B-407.4.10 shall be provided on at least one wall of the car....
-
4.9.4(3)
(3) The clear space between handrails and wall shall be 1‒1/2 in (38 mm)....
-
4.8.5(3)
(3) The clear space between the handrail and the wall shall be 1 - 1/2 in (38 mm)....
-
11B-411.4.10 Support rail
Support rails complying with Section 11B-407.4.10 shall be provided on at least one wall of the car....
-
11B-411.4.10 Support rail
Support rails complying with Section 11B-407.4.10 shall be provided on at least one wall of the car....
-
11B-813.2.1 Adult changing table
Adult changing tables shall be fixed to the floor or a wall and shall comply with Section 11B-813.2.1....
-
Landscape Forms Inc. FLO 3 Section Bike Rack
May be embedded or surface mounted at ends Nylon glides cushion the surface contact point of 2 intermediate loops Refer to installation guide to meet APBP Guidelines for bike rack spacing...
-
AJW Architectural Products UJ14 Series UJ14A Hook Strip 26"L, 3 Hooks - Surface Mounted
Ends of strip are returned 1/2"to wall surface. Hooks: Fabricated of #14 gauge stainless steel finished to match strip....
-
Viking Tactile Blue Braille and Raised Letter Sign
The unit can be ceiling mounted, mounted flat against a wall or end mounted so it can be viewed from either direction....
-
Kitchens and Kitchenettes
Section 4.34.6 requires a clearance between opposing base cabinets, counters, appliances, or walls of at least 40 inches except in a U-shaped kitchen where the minimum clearance is 60 inches...
-
Salsbury Industries 61000 Series Single Tier Standard Metal Lockers
lockers have a compartment size that is 12" wide, 72" high and 12", 15" or 18" deep Available as 1 wide or 3 wide units Each locker compartment features an adjustable hat shelf, 3 single wall...
-
Salsbury Industries 61000 Series Single Tier 3 Wide Standard Metal Lockers
lockers have a compartment size that is 12" wide, 72" high and 12", 15" or 18" deep Available as 1 wide or 3 wide units Each locker compartment features an adjustable hat shelf, 3 single wall...
-
Podium
., have everyone sit at a head table with a tabletop microphone) or provide the speaker who has a disability with a hand-held or lavaliere microphone to allow her to speak from a position...
-
1009.2 Pool Lifts
Additional options such as armrests, head rests, seat belts, and leg support will enhance accessibility and better accommodate people with a wide range of disabilities....
-
Accessible Routes
The accessible route must comply with ADAAG provisions for the location, width (minimum of 36 inches), passing space, head room, surface, slope (maximum of 1:12 or 8.33%), changes in level...
-
Accessible Routes
Accessible route requirements in ADAAG address width (minimum of 36 inches), passing space, head room, surface, slope (maximum of 1:12 or 8.33%), changes in level, doors, egress, and areas...
-
1009.2 Pool Lifts
Additional options such as armrests, head rests, seat belts, and leg support will enhance accessibility and better accommodate people with a wide range of disabilities....
-
1011.7 Outdoor Rinsing Showers
EXCEPTION: Where vandalism is a consideration, a fixed shower head located at 48 inches (1220 mm) above the ground shall be permitted in place of a hand-held shower spray unit....
-
1011.7 Outdoor Rinsing Showers
EXCEPTION: Where vandalism is a consideration, a fixed shower head located at 48 in (1220 mm) above the ground shall be permitted in place of a hand-held shower spray unit....
