nondiscrimination/civil rights requirements), Executive Order 12630 (concerning property rights), Executive Order 12988 (concerning civil justice reform), and Executive Order 13045 (protection of children...
Search Results "Children's Dimension"
Commonly Searched Documents
-
National Environmental Policy Act
- Innerface Trio Interior Signage
- Don-Jo Mfg., Inc. Pull Plate CFC7015
- DORMA ED900 Low-Energy Swing Door Operator
- AssistiveWare News-2-You
-
Space Needs
Percentage of subjects who were able to transfer within each clear floor space dimension for Protocol A transfer TO and FROM the platform at their maximum height (Max) and minimum height...
-
5.2.1.1 Transfer Surface Width Recommendations for M301
Some supported the 28-inch dimension noting there is little gain in usability by increasing the transfer surface width to 30....
-
1. Question: What is the minimum width needed for a non-level boarding railroad passenger station platform to meet the accessibility requirements of the Americans with Disabilities Act (ADA)?
conventional non-level boarding side passenger platform with a railing or wall on the platform side opposite the track, the minimum platform width thus should be the sum of the maximum dimensions...
- Pilot Rock AFT Series - End Accessible Traditional A-Frame Picnic Table - Using Recycled Plastic
- Pilot Rock AFT Series - End Accessible Traditional A-Frame Picnic Table - Using Lumber
- Living Earth Crafts Essex™ Pedicure Chair
-
Q2.) What are the types of “field conditions” that were anticipated where the advisory says “tolerances recognized by this provision include those for field conditions”?
Those are usually the dimensions that can safely be considered industry tolerances. ...
-
R305 Detectable Warning Surfaces (Section-by-Section Analysis)
The dimensions for dome size and dome spacing are the same as in the 2004 ADA and ABA Accessibility Guidelines....
-
T303 Handrails, Stanchions, and Handholds
Accordingly, in the final rule, the Board has lowered the minimum dimension for seat-back handhold cross sections from 1 ¼ inches (32 mm) to 7/8 inches (22 mm)....
-
3.3.5 Seat Height
3.3.5 Seat Height Height dimension standards for seats prescribed in the Australian, Canadian and U.S. standards were very similar (480 mm or 18.9 in., 480 mm or 18.9 in. and 485 mm...
-
Suggested accessibility guidelines for exterior concrete surfaces
However, the ACI standards do not permit interpolation or extrapolation for dimension greater than or less than 10 feet....
-
Areas for further work
Measurement instruments Accuracy of instruments/measurement uncertainty Use of significant figures Metric conversions or dual unit standards Measurement of dimensions...
-
2004 ADA and ABA Accessibility Guidelines
The Access Board is also considering additional technical criteria based on the 2004 ADA and ABA Accessibility Guidelines for cross section dimensions and clearances around gripping surfaces...
- Election Systems & Software ADA Sip-N-Puff - AutoMark
-
Can parking signage height be considered a "safe harbor"?
No specific height dimension given. For an older property with parking signs mounted at, say 45" inches to the bottom, are these protected by the safe harbor rule? ...
-
Existing play areas. (Section-by-Section Analysis)
In adopting the 2004 ADAAG (which includes the 2000 play area guidelines), the Department acknowledges both the importance of integrated, full access to play areas for children and parents...
- Delta Single Handle Basin Faucet 570LF-WFHDF
- Omnia Industries Inc. Interior Modern Lever Latchset with Square Rose - Stainless Steel No.25S
- Don-Jo Mfg., Inc. Pull Plate 7011