Signs with tactile characters shall comply with 703.4....
Search Results "Tow-Away Warning Sign"
Filters
Commonly Searched Documents
-
Installation Height and Location: ADA Standard Section 703.4
-
11B-247.1.2.3 Islands or cut-through medians
Islands or cut-through medians shall have detectable warnings complying with Sections 11B-705.1.1 and 11B-705.1.2.3. ...
-
11B-247.1.2.3 Islands or cut-through medians
Islands or cut-through medians shall have detectable warnings complying with Sections 11B-705.1.1 and 11B-705.1.2.3....
-
11B-247.1.2.3 Islands or cut-through medians
Islands or cut-through medians shall have detectable warnings complying with Sections 11B-705.1.1 and 11B-705.1.2.3....
-
C2-2. Undersides of Exterior Stairs
[ADA Stds 4.4.2] Yes _____ No _____ If No, can a barrier or enclosure be added below the stair or can the route be relocated away from the stair?...
-
11B-406 Curb ramps, blended transitions and islands
Islands are addressed at 2010 ADAS 406.7, almost identical to CBC, except for detectable warnings. See also U.S. Access Board's Note to Reader at Detectable Warnings....
-
Wayfinding is more than just graphics (slides 2 – 4)
Go through the stop sign. Take a left. It’s the second blue house on the left.”...
-
11B-703.4 Installation height and location
Signs with tactile characters shall comply with Section 11B-703.4....
-
11B-216.4 Means of egress
Signs for means of egress shall comply with Section 11B-216.4....
-
Check-Out Aisles: ADA Standard Section 216.11
Section 216.11 covers scoping requirements in the current ADA Standards for signs at check-out aisles.
-
23. Q: What types of modifications in law enforcement policies, practices, and procedures does the ADA require?
Example: A department modifies its regular practice of handcuffing arrestees behind their backs, and instead handcuffs deaf individuals in front in order for the person to sign or write...
-
1010.2.13.1 Delayed egress locking system
A sign shall be provided on the door and shall be located above and within 12 inches (305 mm) of the door exit hardware: 6.3....
-
11B-207.1 General
Directional signs shall be provided in compliance with Chapter 10, Section 1009.10. Advisory 11B-207 Accessible means of egress....
-
Attachment J: Access to Humboldt County Programs Housed in Others’ Facilities
Attachment J: Access to Humboldt County Programs Housed in Others’ Facilities
-
11B-406 Curb ramps, blended transitions and islands
Islands are addressed at 2010 ADA Standards 406.7, almost identical to CBC, except for detectable warnings. See also U.S. Access Board's Note to Reader at Detectable Warnings....
-
TTYs: ADA Standard Section 216.9
Section 216.9 covers scoping requirements in the current ADA Standards for signs for TTYs.
-
A4.10.7 Door and Signal Timing for Hall Calls
This paragraph allows variation in the location of call buttons, advance time for warning signals, and the door-holding period used to meet the time requirement....
-
A4.10.7 DOOR AND SIGNAL TIMING FOR HALL CALLS
This paragraph allows variation in the location of call buttons, advance time for warning signals, and the door-holding period used to meet the time requirement....
-
11 [§ 4.7.6]
11 [§ 4.7.6] A built-up curb ramp typically consists of asphalt or concrete that is poured and shaped into a ramp that runs at a 90-degree angle away from an intact curb down to the roadway...
-
Notification Devices
Also, telephones must be served by an accessible outlet not more than 4 feet away to facilitate use of TTYs....
-
11B-216.5.3 Parking and electric vehicle charging facilities
Signs within parking and charging facilities shall comply with Section 11B-216.5.3....
-
907.2.10 Single-and multiple-station smoke alarms
Listed single-and multiple-station smoke alarms shall be installed in accordance with the provisions of this code and the household fire-warning equipment provisions of NFPA 72....
-
11B-406 CURB RAMPS, BLENDED TRANSITIONS AND ISLANDS
Islands are addressed at 2010 ADAS 406.7, almost identical to 2013 CBC, except for detectable warnings. See also U.S. Access Board's Note to Reader at Detectable Warnings....
-
11B-812.8.6 Finish and size
Identification signs shall be reflectorized with a minimum area of 70 square inches (45161 mm2)....