Permanent seats at the head end of the bathtub shall be 15 inches (380 mm) deep minimum and shall extend from the back wall to or beyond the outer edge of the bathtub....
Search Results "Wing Wall"
-
610.2 Bathtub Seats
-
804.3.1 Clear Floor or Ground Space
conditions are met: (a) the cabinetry can be removed without removal or replacement of the kitchen work surface; (b) the finish floor extends under the cabinetry; and (c) the walls...
-
609.3 Spacing
The space between the wall and the grab bar shall be 1½ inches (38 mm). The space between the grab bar and projecting objects below and at the ends shall be 1½ inches (38 mm) minimum....
-
11B-610.2 Bathtub seats
Permanent seats at the head end of the bathtub shall be 15 inches (381 mm) deep minimum and shall extend from the back wall to or beyond the outer edge of the bathtub....
-
11B-804.3.1 Clear floor or ground space
conditions are met: (a) the cabinetry can be removed without removal or replacement of the kitchen work surface; (b) the finish floor extends under the cabinetry; and (c) the walls...
-
Size and Clearances [4.21.2]
Recommendations: Consider additional clear floor space beyond the control wall to facilitate the reach to controls....
-
Exposed Pipes and Surfaces [4.19.4]
The P-trap may also be installed parallel to the wall so that it is located outside the knee/toe space....
-
General [5.1]/ Access Aisles [5.3]
The required clear width (36 inches minimum) is specified for the clearance between the edges of fixed tables or between table edges and walls....
-
F213.1 General
Some pit toilets do not have walls and would not be able to comply with the technical requirements for toilet facilities such as providing grab bars at toilet fixtures....
-
609.4 Position of Grab Bars
The height of the lower grab bar on the back wall of a bathtub shall comply with 607.4.1.1 or 607.4.2.1....
-
Doors and Gates in Series [§404.2.6]
Recommendation: Wheelchair space 30” min. by 48” min. beyond the swing of a door in other configurations, such as vestibules with doors on adjacent walls, will provide room to clear one...
-
11B-804.3.1 Clear floor or ground space
conditions are met: (a) the cabinetry can be removed without removal or replacement of the kitchen work surface; (b) the finish floor extends under the cabinetry; and (c) the walls...
-
11B-804.3.1 Clear floor or ground space
met: (a) the cabinetry can be removed without removal or replacement of the kitchen work surface; (b) the finish floor extends under the cabinetry; and (c) the walls...
-
Plan 5A: 13-Foot Wide Accessible Guest Room
Circular turning space in room (section 603.2.1); • Required clear floor spaces at fixtures and turning space overlap (section 603.2.2); • Water closet clearance is 60 inches at back wall...
-
Plan 5B: 13-Foot Wide Accessible Guest Room
T-shaped turning space in room (section 603.2.1); • Required clear floor spaces at fixtures and turning space overlap (section 603.2.2); • Water closet clearance is 60 inches at back wall...
-
Mounting Height and Location
At double doors with two active leafs, signs are to be located on the right-hand side or, if no wall space is available, on the nearest adjacent wall....
-
Q2.) What are the types of “field conditions” that were anticipated where the advisory says “tolerances recognized by this provision include those for field conditions”?
For example, a skilled brick mason cannot lay a perfectly vertical and straight wall. A skilled tile layer cannot create a perfectly flat wall behind a toilet room grab bar. ...
-
Accessible
Housing Act refers to design features that include both the minimal "accessibility" features required to be built into the unit, and the "adaptable" feature of reinforcement for bathroom walls...
-
407.4.1 Car Dimensions
Minimum Dimensions Door Location Door Clear Width Inside Car, Side to Side Inside Car, Back Wall...
-
1134A.8 Lavatories, vanities, mirrors and towel fixtures
Vanities and lavatories shall be installed with the centerline of the fixture a minimum of 18 inches (457 mm) horizontally from an adjoining wall or fixture to allow for forward approach...
-
11B-609.4 Position of grab bars
The height of the lower grab bar on the back wall of a bathtub shall comply with Section 11B-607.4.1.1 or 11B-607.4.2.1....
-
Protruding Objects
Wall-mounted objects, with bottom edges between 27 inches and 80 inches above the floor, cannot protrude into the route more than four inches....
-
804.3.1 Clear Floor or Ground Space
conditions are met: (a) the cabinetry can be removed without removal or replacement of the kitchen work surface; (b) the finish floor extends under the cabinetry; and (c) the walls...
-
608.2.1 Transfer Type Shower Compartments
Clearance of 36 inches (915 mm) wide minimum by 48 inches (1220 mm) long minimum measured from the control wall shall be provided....