Some pit toilets do not have walls and would not be able to comply with the technical requirements for toilet facilities such as providing grab bars at toilet fixtures....
Search Results "Wing Wall"
Filters
Commonly Searched Documents
-
F213.1 General
-
609.4 Position of Grab Bars
The height of the lower grab bar on the back wall of a bathtub shall comply with 607.4.1.1 or 607.4.2.1....
-
Doors and Gates in Series [§404.2.6]
Recommendation: Wheelchair space 30” min. by 48” min. beyond the swing of a door in other configurations, such as vestibules with doors on adjacent walls, will provide room to clear one...
-
11B-804.3.1 Clear floor or ground space
conditions are met: (a) the cabinetry can be removed without removal or replacement of the kitchen work surface; (b) the finish floor extends under the cabinetry; and (c) the walls...
-
11B-804.3.1 Clear floor or ground space
met: (a) the cabinetry can be removed without removal or replacement of the kitchen work surface; (b) the finish floor extends under the cabinetry; and (c) the walls...
-
1134A.8 Lavatories, vanities, mirrors and towel fixtures
Vanities and lavatories shall be installed with the centerline of the fixture a minimum of 18 inches (457 mm) horizontally from an adjoining wall or fixture to allow for forward approach...
-
Water Closet Location.
In addition, at Beechwood Home where the lavatory was located adjacent to the toilet on the opposite side, the rear wall behind the toilet was pulled out so that the back of the toilet was...
-
11B-609.4 Position of grab bars
The height of the lower grab bar on the back wall of a bathtub shall comply with Section 11B-607.4.1.1 or 11B-607.4.2.1....
-
Protruding Objects
Wall-mounted objects, with bottom edges between 27 inches and 80 inches above the floor, cannot protrude into the route more than four inches....
-
804.3.1 Clear Floor or Ground Space
conditions are met: (a) the cabinetry can be removed without removal or replacement of the kitchen work surface; (b) the finish floor extends under the cabinetry; and (c) the walls...
-
608.2.1 Transfer Type Shower Compartments
Clearance of 36 inches (915 mm) wide minimum by 48 inches (1220 mm) long minimum measured from the control wall shall be provided....
-
Parallel Grab Bars
Two parallel grab bars are required on the back wall of bathtubs with seats (607.4.1.1) and without seats (607.4.2.1)....
-
404.2.4.3 Recessed Doors and Gates
A door can be recessed due to wall thickness or because of the placement of casework and other fixed elements adjacent to the doorway....
-
610.2 Bathtub Seats
Permanent seats at the head end of the bathtub shall be 15 inches (380 mm) deep minimum and shall extend from the back wall to or beyond the outer edge of the bathtub....
-
404.2.4.3 Recessed Doors and Gates
A door can be recessed due to wall thickness or because of the placement of casework and other fixed elements adjacent to the doorway....
-
609.4 Position of Grab Bars
The height of the lower grab bar on the back wall of a bathtub shall comply with 607.4.1.1 or 607.4.2.1....
-
Adaptability
It is not intended to include moving walls, relocating plumbing, replacing fixtures, widening door frames, or other work more appropriately addressed in design and construction....
-
Pit Toilet
A pit toilet riser may or may not be surrounded by walls and may or may not have a roof. ...
-
Pit Toilet
A pit toilet riser may or may not be surrounded by walls and may or may not have a roof....
-
Emotional impact
And then he took me to the marble wall that had the names carved in it. And he was like here, touch the names. These are the names.”...
-
Pit Toilet
A pit toilet riser may or may not be surrounded by walls and may or may not have a roof. ...
-
11B-609.4 Position of grab bars
The height of the lower grab bar on the back wall of a bathtub shall comply with Section 11B-607.4.1.1 or 11B-607.4.2.1....
-
Clear floor space
It appears that a minimum 6'-6" rear wall would be required if bench is parallel to a wall?...