At housing at a place of education, the requirement that travel between fixtures does not require travel between other parts of the guest room shall have “guest room” interchangeable with...
Search Results "Polling Place"
Commonly Searched Documents
-
11B-806.2.4 Toilet and bathing facilities
- Bobrick MatrixSeries Surface-Mounted Multi-Roll Toilet Tissue Dispenser B-5288
- Shelter Shutters
-
3. Automatic Call Distribution (ACD)
ACD places incoming calls into a queue, sends out a programmed message to callers to let them know that their calls have been received, and distributes calls to the next available call taker...
-
Q: What is HCO? Who uses it?
HCO can be accomplished by a call taker using standard stand-alone TTY equipment by alternating speaking into the handset and placing the handset in the TTY when the caller types a response...
-
11B-809.5.5.2 Identification
Such peepholes can be placed at a standard height and permit a view from several feet from the door....
-
T402.2 Design Load
Ramps and bridgeplates 30 inches (760 mm) or more in length shall be designed to support a load of 600 pounds (273 kg) minimum, placed at the centroid of the ramp distributed over an area...
-
Adjustable gap protocol
Adjustable gap protocol: From initial setup, just the horizontal distance between the WMD and platform was incrementally increased by placing plywood blocks of 3.5” (8.9cm) width between...
-
Architectural Barriers
Assuming your place of lodging is not subject to the new construction and alteration provisions (discussed below), you must remove barriers to access for people with disabilities when it...
-
604.8.2.2 Doors
A door pull complying with 404.2.7 shall be placed on both sides of the door near the latch. Toilet compartment doors shall not swing into the minimum required compartment area....
-
809.5.5.2 Identification
Such peepholes can be placed at a standard height and permit a view from several feet from the door....
-
Develop a Plan
Although places of public accommodation are not required to have a plan, the Department of Justice recommends one: "...Such a plan...could serve as evidence of a good faith effort to comply...
-
12162(a)(4)(A)(ii)
Unless not practicable, a person providing intercity rail transportation shall place an accessible car adjacent to the end of a dining car described in clause (I) through which an individual...
-
1016.6 Openings
Elongated openings should be placed so that the long dimension is perpendicular, or as close to perpendicular as possible, to the dominant direction of travel....
-
Section 36.101 Purpose (Section-By-Section Analysis and Response to Comments)
This title prohibits discrimination on the basis of disability by public accommodations, requires places of public accommodation and commercial facilities to be designed, constructed, and...
-
11B-809.5.5.2 Identification
Such peepholes can be placed at a standard height and permit a view from several feet from the door....
-
11B-221.2 Wheelchair spaces
NOTE: When required wheelchair spaces are not occupied by persons eligible for those spaces, individual, removable seats may be placed in those spaces. ...
-
11B-809.5.5.2 Identification
Such peepholes can be placed at a standard height and permit a view from several feet from the door. ◼...
-
11B-221.2 Wheelchair spaces
NOTE: When required wheelchair spaces are not occupied by persons eligible for those spaces, individual, removable seats may be placed in those spaces....
-
11B-703.6.1 Pictogram field
The required equivalent verbal description must be placed below the pictogram, and may not intrude into the 6-inch field. ◼ ...
-
F. Shelter Environment
This requirement extends beyond the “accessible route” and applies throughout the shelter environment to any place where a person can walk....
-
221.2.3.2 Vertical Dispersion
When wheelchair spaces are dispersed vertically in an assembly facility they are placed at different locations within the seating area from front-to-back so that the distance from the screen...