Dining counters (where there is no service) are typically found in small carry-out restaurants, bakeries, or coffee shops and may only be a narrow eating surface attached to a wall....
Search Results "Removable Seat"
-
A5.1 General
-
Sioux Chief DropKick™ Offset Flange 889-45PAM
Full-flow, 3" I.D. throat – no restriction Solvent welds inside 3" Sch. 40 fitting hub Corrosion-resistant 430 stainless steel swivel ring is engineered for maximum...
-
Oatey Level Fit Offset Closet Flange Metal Ring 43501 - PVC
The metal ring provides added strength and cracking resistance to the flange and can be rotated to allow precise alignment of bolts and screws. Solvent welds inside of 4" or...
-
Oatey Level Fit Offset Closet Flange Metal Ring 43804 - PVC Bulk
The metal ring provides added strength and cracking resistance to the flange and can be rotated to allow precise alignment of bolts and screws. Solvent welds inside of 4" or...
-
Oatey Level Fit Offset Closet Flange Metal Ring 43500 - ABS 15150
The metal ring provides added strength and cracking resistance to the flange and can be rotated to allow precise alignment of bolts and screws. Solvent welds inside of 4" or...
-
Sioux Chief FullFlush™ Offset Flange 889-AOM
Full-flow, 3" I.D. throat – no restriction Allows for 1?½" offset in any direction for closet bowl setting Corrosion-resistant 430 stainless steel swivel ring is engineered...
-
Zurn Z1209 Vertical Offset Siphon Jet Water Closet Support System
FEATURES: Vertical, offset water closet carrier 300 lb. load capacity
-
5.2.2.1 Transfer Surface Width
The transfer surface should be 21 inches wide minimum for examination chairs and other equipment used by patients in a seated position....
-
M302.3.1 Transfer Supports (Section-by-Section Analysis)
In the MDE NPRM the Access Board proposed that transfer supports must be provided for use with transfer sides on diagnostic equipment used by patients in the seated position, and that these...
-
T605 Seat Belts and Shoulder Belts
[See subsections ...]
-
Service Animals
However, in order to guarantee your seat assignment, you should be aware that, depending on whether the carrier provides advance seat assignments and the type of seating method it uses,...
-
Guest Bathrooms
The depth of a removable in-tub seat shall be 15 inches (380 mm) minimum and 16 inches (405 mm) maximum. The seat shall be capable of secure placement....
-
§ 36.304(c)(1)
(1) First, a public accommodation should take measures to provide access to a place of public accommodation from public sidewalks, parking, or public transportation. These measures...
-
Sec.36.304(c)(1)
(1) First, a public accommodation should take measures to provide access to a place of public accommodation from public sidewalks, parking, or public transportation. These measures...
-
SELLING OR SERVING SPACE
§36.304(f) SELLING OR SERVING SPACE. The rearrangement of temporary or movable structures, such as furniture, equipment, and display racks is not readily achievable to the extent...
-
Figure 802.2.1.1 Lines of Sight Over the Heads of Seated Spectators – Drawing from the U.S. Access Board
-
Figure 802.2.1.2 Lines of Sight Between the Heads of Seated Spectators – Drawing from the U.S. Access Board
-
§382.117(b)
(b) You must permit the service animal to accompany the passenger with a disability at any seat in which the passenger sits, unless the animal obstructs an aisle or other area that must...
-
§ 35.138 Ticketing.
[See subsections ...]
-
M302.2.2 Size
The size requirements in this section apply only to the portion of the seat used for transfer....
-
221.2.3.1 Horizontal Dispersion
Horizontal dispersion shall not be required in assembly areas with 300 or fewer seats if the companion seats required by 221.3 and wheelchair spaces are located within the 2nd or 3rd quartile...
-
221.2.3.1 Horizontal Dispersion
Horizontal dispersion shall not be required in assembly areas with 300 or fewer seats if the companion seats required by 221.3 and wheelchair spaces are located within the 2nd or 3rd quartile...
-
4.1.6(3)(f)(i)
(i) Where it is technically infeasible to disperse accessible seating throughout an altered assembly area, accessible seating areas may be clustered....
-
§ 38.125(d)(2) Wheelchair or mobility aid spaces
Not more than 6 inches of the required clear floor space may be accommodated for footrests under another seat provided there is a minimum of 9 inches from the floor to the lowest part of...
