Elevator safety is regulated by the California Department of Occupational Safety and Health, Elevator Ride and Tramway Unit - see Title 8, California Code of Regulations for more information...
Search Results "Ride Entry"
Filters
Commonly Searched Documents
-
11B-407.1 General
-
M303.2.6 Edge Protection (Section-by-Section Analysis)
spaces that are raised more than 1½ inches in height to provide a minimum 2-inch-high edge protection, measured from the surface of the platform, on each side of the platform not providing entry...
-
Clearances for Side Approaches
These clearances, which are permitted to overlap, may determine the width of corridors, including entry alcoves with offset doors....
-
Accessible Route - Exterior
Result: People with disabilities cannot travel from the site entry points to the accessible entrance(s). In some cases, people must use vehicular routes which can be dangerous....
-
§ 38.83(a)(1) General
All new light rail vehicles, other than level entry vehicles, covered by this subpart shall provide a level-change mechanism or boarding device (e.g., lift, ramp or bridge plate) complying...
-
SDC Bollard Post with Push Plate or Touch Panel
Alternative to wall mounted access control or switches for entry doors. Bollard post provide visibility and meet accessibility guidelines....
-
TownSteel CP Series Grade 3 Cylindrical Lockset Cylindrical Locks
Specification: Door Thickness 1-3/8" - 1-3/4" Backset 2-3/8" to 2-3/4" adjustable Faceplate 1" wide with square corner Strike Steel, T-Strike Function Entry, Privacy, Passage...
-
Universal Industrial Products SOSS UltraLatch
The SOSS® UltraLatch® is a totally new concept in door entry hardware. Designed to be the most convenient, practical and aesthetically pleasing door latch you have ever used....
-
M. NEW CONSTRUCTION, ALTERATIONS, AND PHYSICAL CHANGES TO FACILITIES
The County will complete all actions identified in Attachments G, H, I, and J no later than thirty-three (33) months from the date of entry of this Consent Decree. ...
-
M. NEW CONSTRUCTION, ALTERATIONS, AND PHYSICAL CHANGES TO FACILITIES
The County will complete all actions identified in Attachments G, H, I, and J no later than thirty-three (33) months from the date of entry of this Consent Decree. ...
-
11B-608.2.2 Standard roll-in type shower compartments
30 inches (760 mm) wide minimum by 60 inches (1525 mm) deep minimum clear inside dimensions measured at center points of opposing sides and shall have a 60 inches (1525 mm) wide minimum entry...
-
2. Are play components that have multiple stations or which can include more than one person using them at one time considered one or two play components?
If required to be accessible, a play component must be on an accessible route, have clear floor or ground space and maneuvering space, and have entry points and seats at the required heights...
-
Ensure that people with mental health disabilities or I/DD have an equal opportunity to participate in and benefit from the entities’ programs, services, and activities
Developed non-discriminatory eligibility criteria for early release, parole, or other re-entry programs....
-
XI. RETENTION OF JURISDICTION
This Court shall retain jurisdiction of this action for a period of three (3) years from the date of entry of this Consent Decree to enforce or modify the provisions of this Consent Decree...
-
(a) Single-story dwelling units
However, split-level entries or areas will need ramps or other means of providing an accessible route....
-
§ 37.42(f)
(f) For purposes of this part, level-entry boarding means a boarding platform design in which the horizontal gap between a car at rest and the platform is no more than 10 inches on tangent...
-
Plumbing/Restrooms
and accessories 11B-603 Clear floor space requirements at fixtures 11B-604 Compartment configuration side and end entry...
-
608.5.3 Alternate Roll-In Type Shower Compartments
Where a seat is not provided, the controls, faucets, and shower spray unit shall be installed on the side wall farthest from the compartment entry....
-
Plumbing/Restrooms
and accessories 11B-603 Clear floor space requirements at fixtures 11B-604 Compartment configuration side and end entry...
-
Angled Van Spaces
Recommendation: Where standard (non-van) accessible spaces are angled or otherwise restrict entry to one direction only, providing one access aisle for each accessible space (or on both...
-
§ 37.42(f)
(f) For purposes of this part, level-entry boarding means a boarding platform design in which the horizontal gap between a car at rest and the platform is no more than 10 inches on tangent...
-
1132A.5.1 General
The floor or landing on the dwelling unit side of the primary entry door and any required exit door shall have a minimum length of not less than 44 inches (1118 mm)....
-
11B-608.2.2 Standard roll-in type shower compartments
30 inches (760 mm) wide minimum by 60 inches (1525 mm) deep minimum clear inside dimensions measured at center points of opposing sides and shall have a 60 inches (1525 mm) wide minimum entry...
-
1132A.5.1 General
The floor or landing on the dwelling unit side of the primary entry door and any required exit door shall have a minimum length of not less than 44 inches (1118 mm)....
