Calculates F-numbers for runs, sections, and surfaces on site Instantly produces profile graphs on site "Instant" downloading to desktop or laptop computer Automatic zeroing Prints...
Search Results "Fire-Building Surface"
Filters
Commonly Searched Documents
-
The Dipstick® Floor Profiler Tool
-
T302 Walking Surfaces
The technical requirements for walking surfaces include provisions on slip resistance, the maximum size of surface openings, and the maximum height of vertical surface discontinuities (i.e...
-
11B-306.3.3 Minimum required depth
At dining and work surfaces required to be accessible by Section 11B-226.1, knee clearance shall extend 19 inches (483 mm) deep minimum at 27 inches (686 mm) above the finish floor or ground...
-
M303.2.5 Surfaces (Section-by-Section Analysis)
The MDE NPRM proposed to require diagnostic equipment used by patients seated in a wheelchair to provide a wheelchair space with a surface that does not slope more than 1:48 in any direction...
-
203.1 General
Sites, buildings, facilities, and elements are exempt from these requirements to the extent specified by 203....
-
809.2.1.2 Floor Surfaces
809.2.1.2 Floor Surfaces This section specifies that carpet not be provided on floor surfaces in emergency transportable housing units with mobility features....
-
Wiring for Visible Alarms [§215.3]
Wiring for Visible Alarms [§215.3] All employee work areas served by audible fire alarms, regardless of size, must be designed to support later installation of visible alarms after...
-
RECOMMENDATIONS
RECOMMENDATIONS An objective test procedure for measuring the firmness and stability of surfaces with a portable device and performance specifications need to be accepted in order to...
-
Exposed Pipes and Surfaces [4.19.4]
Exposed Pipes and Surfaces [4.19.4] To prevent burns, hot water pipes and drain pipes under lavatories must be insulated or otherwise configured to protect against contact....
-
Inpro Corporation JointMaster® DR Series Seal Expansion Joint Systems
not weather sensitive Utilizes lubricant adhesive (JPR004) Key Specifications: Architectural Compression Seals Joint width: 3/4"-1-3/4" Optional fire...
-
11B-233.3.1.2.4 Multi-story residential dwelling units in buildings with one or more elevators
In elevator buildings, facilities with multi-story residential dwelling units shall comply with the following: The primary entry of the multi-story residential dwelling unit shall...
-
606.5 Exposed Pipes and Surfaces
606.5 Exposed Pipes and Surfaces. Water supply and drain pipes under lavatories and sinks shall be insulated or otherwise configured to protect against contact....
-
Compliance Determinations by State and Local Jurisdictions
to attend staff reviews of every building permit request....
-
Nystrom Building Products MatDesign Roll-Up Mats
MatDesign™ Roll-Up Mats Aluminum rail mats with ball and socket aluminum hinges with drain holes to allow debris and moisture to flow through the mat Hinges maintain their...
-
804.3 Kitchen Work Surface
804.3 Kitchen Work Surface....
-
408.4.2 Floor Surfaces
408.4.2 Floor Surfaces. Floor surfaces in elevator cars shall comply with 302 and 303....
-
1.9.1.2.1
1.9.1.2.1 Any building, structure, facility, complex or improved area, or portions thereof, which are used by the general public. Advisory 1.9.1.2.1....
-
1.9.1.2.1
1.9.1.2.1 Any building, structure, facility, complex or improved area, or portions thereof, which are used by the general public. Advisory 1.9.1.2.1....
-
Visible Alarms
The 1991 Standards, at section 4.1.1(3), require visible alarms to be provided where audible fire alarm systems are provided, but do not require areas used only by employees as work areas...
-
4.1.1(2) Application Based on Building Use
(2) Application Based on Building Use....
-
R202.3.4 Alterations to Qualified Historic Facilities
R202.3.4 Alterations to Qualified Historic Facilities. Where the State Historic Preservation Officer or Advisory Council on Historic Preservation determines that compliance with a...
-
Clear Floor or Ground Space: ADA Standard Section 902.2
A clear floor space complying with 305 positioned for a forward approach shall be provided. Knee and toe clearance complying with 306 shall be provided.
-
11B-902.2 Clear floor or ground space
A clear floor space complying with Section 11B-305 positioned for a forward approach shall be provided. Knee and toe clearance complying with Section 11B-306 shall be provided.
-
6. Minimum (Low) Height Standard for Transfer Surfaces
Minimum (Low) Height Standard for Transfer Surfaces As indicated in Section 5.1.1, the MDE Advisory Committee recommends that equipment with transfer surfaces be height adjustable in...
