(4) Ground surfaces along accessible routes and in accessible spaces shall comply with 4.5....
Search Results "Work Surface"
-
4.1.2(4)
-
4.9.4(4)
(4) Gripping surfaces shall be uninterrupted by newel posts, other construction elements, or obstructions....
-
4.1.1(4)
(4) Ground surfaces along accessible routes and in accessible spaces shall comply with 4.5....
-
405.9.1 Extended Floor or Ground Surface
The floor or ground surface of the ramp run or landing shall extend 12 inches (305 mm) minimum beyond the inside face of a handrail complying with 505....
-
Husky 10" Multi-Function Standard Digital Level
Accurate to 1/10° LCD digital display inverts when the level is inverted for convenience when working overhead 3 measurement units: degrees, percentage, or inches of rise...
-
Filter Pave™ Porous Paving for Stormwater Management Informational Video
Filter Pave™ Porous Paving for Stormwater Management Informational Video
-
1005.3.2 Extended Ground or Deck Surface
1005.3.2 Extended Ground or Deck Surface. The ground or deck surface shall extend 12 inches (305 mm) minimum beyond the inside face of the railing....
-
Seat Width Evaluation
many participants (the 25th through 95th percentiles) for their level, highest and lowest height transfer regardless of the presence or absence of grab bars or a backrest on the transfer surfaces...
-
Slope
The 2010 Standards provide, at section 403.3, that the cross slope of walking surfaces not be steeper than 1:48....
-
11B-505.4 Height
Top of gripping surfaces of handrails shall be 34 inches (864 mm) minimum and 38 inches (965 mm) maximum vertically above walking surfaces, stair nosings, and ramp surfaces....
-
11B-505.4 Height
Top of gripping surfaces of handrails shall be 34 inches (864 mm) minimum and 38 inches (965 mm) maximum vertically above walking surfaces, stair nosings, and ramp surfaces....
-
§ 38.23(c)(2) Ramp surface
(2) Ramp surface....
-
§ 38.83(c)(2) Ramp surface
(2) Ramp surface....
-
5.2.3 Transfer Surface Measurement
5.2.3 Transfer Surface Measurement. The transfer surface should be measured from the center-point of each side of the transfer surface....
-
§ 38.125(c)(2) Ramp surface
(2) Ramp surface....
-
Tile Tech Pavers® Oceanic™ Series - Wave-Pave™
pavers can also be manufactured with various design mixes such as crushed seashells, granite chips and recycled glass which are then honed and shot blasted for a unique and slip resistant surface...
-
Visible Alarms
These commenters also raised concerns that all employee work areas within existing buildings and facilities must be equipped with accessibility features....
-
1005.3.2 Extended Ground or Deck Surface
The ground or deck surface shall extend 12 inches (305 mm) minimum beyond the inside face of the railing....
-
1.2.2
1.2.2 When flatness of running slope for an accessible surface other than a ramp is measured according to Section 1.1.5 no more than 20% (rounded to the nearest whole number) of the measurements...
-
5.2.2.1 Transfer Surface Width Recommendations for M302
5.2.2.1 Transfer Surface Width Recommendations for M302 The Committee recommends 21 inches for the minimum width of the transfer surface of examination chairs and other equipment primarily...
-
Executive Summary
After traveling over each surface, subjects were asked to subjectively rate each surface and decide whether the surface was acceptable or not....
-
502.4 Floor or Ground Surfaces
502.4 Floor or Ground Surfaces. Parking spaces and access aisles serving them shall comply with 302. Access aisles shall be at the same level as the parking spaces they serve....
-
Question 2
Are the surfaces of all elements of the parking area and accessible route smooth and free of large cracks and broken or raised areas?...
