Our ADA compliant Galvanized Steel Ramp Systems are designed for permanent or semi-permanent ramp situations....
Search Results "Ramp Rise"
Filters
Commonly Searched Documents
-
Handi-Ramp Galvanized Steel Ramps
-
11B-405.7.2 Width
The landing clear width shall be at least as wide as the widest ramp run leading to the landing....
-
EZ-ACCESS GATEWAY™ Solid Surface Portable Ramp
The Gateway™ Solid Surface Portable Ramp – the 1-piece design means no assembly or moveable parts; just set the ramp in the desired position, and it’s ready to use....
-
SECTION 1012 RAMPS
[DSA-AC] In addition to the requirements of this section, means of egress, which provide access to, or egress from, buildings or facilities where accessibility is required for...
-
Ramps
Ramps Ramps serve as a continuation of the accessible route from the ground allowing individuals who use mobility devices to access elevated components....
-
Ramps
If any part of the accessible route - exterior or interior - has a slope greater than 1:20, it is considered a ramp and must meet the requirements for ramps....
-
11B-406.5.10 Diagonal curb ramps
Diagonal or corner type curb ramps are perpendicular or parallel curb ramps that are oriented diagonally at an intersection....
-
Ramps [4.8]
Where the running slope of an accessible route is more than 5%, it is considered a ramp. Generally, changes in level up to 6 inches can be treated as a curb ramp....
-
Doorways: ADA Standard Section 405.7.5
Section 405.7.5 covers the current ADA Standards for doorway maneuvering clearance at ramp landings.
-
Slope: ADA Standard Section 405.7.1
Section 405.7.1 covers the current ADA Standards for the slope in ramp landings.
-
11B-405.9 Edge protection
Edge protection complying with Section 11B-405.9.2 shall be provided on each side of ramp runs and at each side of ramp landings. [2010 ADA Standards] 405.9 Edge Protection....
-
Edge Protection: ADA Standard Section 405.9
Section 405.9 covers the current ADA Standards for edge protection at ramps.
-
Accessible Routes: ADA Standard Section 1007.2
A slope not steeper than 1:4 for a 4 inch (100 mm) maximum rise shall be permitted. 4. Ramp landing slopes specified by 405.7.1 shall be permitted to be 1:20 maximum. 5....
-
11B-705.1.2.2.1 Perpendicular curb ramps
Detectable warnings at perpendicular curb ramps shall extend 36 inches (914 mm) in the direction of travel....
-
Ramp
Ramp - A walking surface that has a running slope of greater than 1:20....
-
11B-1007.2 Accessible routes
A slope not steeper than 1:4 for a 4 inch (102 mm) maximum rise shall be permitted. Ramp landing slopes specified by Section 11B-405.7.1 shall be permitted to be 1:20 maximum....
-
Figure 405.7 Ramp Landings – Drawing from the U.S. Access Board
-
11B-406.3.1 Slope
The running slope of the curb ramp segments shall be in-line with the direction of sidewalk travel. Ramp runs shall have a running slope not steeper than 1:12....
-
Boat Launch Ramp
A sloped surface designed for launching and retrieving trailered boats and other water craft to and from a body of water.
-
BOAT LAUNCH RAMP
[DSA-AC] A sloped surface designed for launching and retrieving trailered boats and other water craft to and from a body of water.
-
11B-505.3 Continuity
Handrails shall be continuous within the full length of each stair flight or ramp run....
-
Continuity: ADA Standard Section 505.3
Section 505.3 covers the current ADA Standards for the continuity of handrails.
-
11B-705.1.2.2.2 Parallel curb ramps
Detectable warnings at parallel curb ramps shall be located so the edge nearest the curb is 6 inches (152 mm) minimum and 8 inches (203 mm) maximum from the demarcation line at the face...
