Products, including those providing voice communication functionality, shall support use of all cross-manufacturer non-proprietary standard signals used by TTYs....
Search Results "Raised Crossing"
Filters
Commonly Searched Documents
-
§1193.51(e) TTY signal compatibility
-
M301.3 Transfer Supports
Circular cross sections – Circular cross sections must have an outside diameter of 1¼ inches minimum and 2 inches maximum....
-
11B-407.4.7.1.3 Symbols
The control button for the emergency stop, alarm, door open, door close, main entry floor, and phone, shall be identified with raised symbols and Braille as shown in Table 11B-407.4.7.1.3...
-
11B-1009.2.6 Footrests and armrests
The armrest positioned opposite the water shall be removable or shall fold clear of the seat when the seat is in the raised position. [2010 ADAS] 1009.2.6 Footrests and Armrests. ...
-
V. Discussion of Principal Public Comment Issues, and Section-by-Section Analysis of the Final Guidelines
The following presents a discussion of the principal issues raised by the commenters, and the Department's response to each issue....
-
11B-1009.2.6 Footrests and armrests
The armrest positioned opposite the water shall be removable or shall fold clear of the seat when the seat is in the raised position. [2010 ADAS] 1009.2.6 Footrests and Armrests....
-
11B-1009.2.6 Footrests and armrests
The armrest positioned opposite the water shall be removable or shall fold clear of the seat when the seat is in the raised (load) position....
-
Public Right-of-Way
Some shared use paths may cross private land....
-
Compliance requirements
requirements The proposed accessibility guidelines address the design, construction, and alteration of pedestrian facilities in the public right-of-way, including sidewalks, pedestrian street crossings...
-
R305.1.4 Size
At pedestrian at-grade rail crossings not located within a street or highway, detectable warnings shall extend the full width of the crossing....
-
11B-502.3 Access aisle
In parking facilities where the accessible route must cross vehicular traffic lanes, marked crossings enhance pedestrian safety, particularly for people using wheelchairs and other mobility...
-
Sides of Curb Ramps [4.7.5]
Where pedestrians cross the ramp, curb ramps are required to have side flares; sharp returns present tripping hazards....
-
Openings [§302.3]
Surface Opening (Cross Section)...
-
409.4.6 Car Controls
Elevator car control buttons shall comply with 409.4.6, 309.3, 309.4, and shall be raised or flush....
-
409.4.6 Car Controls
Elevator car control buttons shall comply with 409.4.6, 309.3, 309.4, and shall be raised or flush....
-
1117B.5.5, Item 2
California's standards for signage are more stringent than Section 4.30 of the ADA Standards for Accessible Design. 1117B.5.5 Raised characters and pictorial symbol signs. ...
-
Technical Requirements [1017]
The technical requirements for trails include specific provisions for the surface, clear tread width, passing spaces, tread obstacles, openings, running slope, cross slope, resting intervals...
-
Elongated surface openings must be perpendicular to the dominant direction of travel, but what if there is no dominant direction of travel?
When there is no dominant direction of cross traffic, openings must be limited to ½” in both dimensions. ...
-
Question 5
Is the surface of the accessible route to the entrance smooth and free of large cracks and broken or raised areas?...
-
Using the Beach Access Route Exceptions [1018.1, Exceptions 1 and 2]
Removable Beach Access Route Requirements Removable beach access routes are not required to comply with the specific requirements for running slope, cross slope, resting intervals, and...
-
Grade (R302.5) (Section-by-Section Analysis)
pedestrian access route is permitted to equal the general grade established for the adjacent street or highway, except that where pedestrian access routes are contained within pedestrian street crossings...
-
703.3.2 Position
Braille shall be separated 3/8 inch (9.5 mm) minimum from any other tactile characters and 3/8 inch (9.5 mm) minimum from raised borders and decorative elements....
-
703.3.2 Position
Braille shall be separated 3/8 inch (9.5 mm) minimum from any other tactile characters and 3/8 inch (9.5 mm) minimum from raised borders and decorative elements....
-
H1
.), is a sign with raised characters and Braille mounted on the wall adjacent to the latch?...