In parking facilities where the accessible route must cross vehicular traffic lanes, marked crossings enhance pedestrian safety, particularly for people using wheelchairs and other mobility...
Search Results "Raised Crossing"
Commonly Searched Documents
-
11B-502.3 Access aisle
-
§ 36.406(f)(4)
(4) In stadium-style movie theaters, wheelchair spaces and companion seats are located on a riser or cross-aisle in the stadium section that satisfies at least one of the following criteria...
-
Obstacles [1016.5]
Frequent obstacles and obstacles that cross the full width of an ORAR can make travel difficult for people using mobility devices....
-
TACTILE SIGN
A sign containing raised characters and/or symbols and accompanying Braille....
-
11B-405.4 Floor or ground surfaces
Changes in level other than the running slope and cross slope are not permitted on ramp runs....
-
§ 1194.23(b)
(b) Telecommunications products which include voice communication functionality shall support all commonly used cross-manufacturer non-proprietary standard TTY signal protocols....
-
§ 35.151(g)(4)
(4) Stadium-style movie theaters locate wheelchair seating spaces and companion seating on a riser or cross-aisle in the stadium section that satisfies at least one of the following criteria...
-
R207.2 Alterations
In alterations where existing physical constraints prevent compliance with R207.1, a single diagonal curb ramp shall be permitted to serve both pedestrian street crossings....
-
§ 35.151(g)(4)
(4) Stadium-style movie theaters shall locate wheelchair spaces and companion seats on a riser or cross-aisle in the stadium section that satisfies at least one of the following criteria...
-
11B-405.4 Floor or ground surfaces
Changes in level other than the running slope and cross slope are not permitted on ramp runs....
-
11B-405.4 Floor or ground surfaces
Changes in level other than the running slope and cross slope are not permitted on ramp runs....
-
11B-406.5.3 Landings
Section 11B-403.5.1.1, requires walks and sidewalks to be 48” wide minimum; Section 11B-403.3 requires walks and sidewalks to have a cross-slope of 1:48 or less....
-
1.1.7 Measurement of parking areas
Overall running slope (in the long dimension) and cross slope (in the short direction) should be measured according to Section 1.1.3 and 1.1.4....
-
Audible WALK indications
close to the crossing it signals.3 Speech WALK indication. ...
-
Expert Report of Douglas J. Anderson, RAS, CASP, LCM Architects (August 8, 2018)
Building Entrance: The raised threshold at the exterior entrance exceeds 1/2 inch (1991 ADA Stds 4.13.8; 2010 ADA Stds 404.2.5)....
-
Car Controls [4.10.12]
In addition to the requirements for control panels shown in ADAAG Figure 23(a): buttons must be raised from, or flush with, the faceplate (or trim ring if provided) in-car...
-
3) Signs
3) Signs ADAAG: * Signs designating permanent rooms and spaces (men's and women's rooms; room numbers; exit signs) must have raised and Brailled letters; must comply with finish and...
-
§ 36.406(f)(4)
(4) Stadium-style movie theaters shall locate wheelchair seating spaces and companion seating on a riser or cross-aisle in the stadium section that satisfies at least one of the following...
-
412.8.3 Signal Compatibility
ICT shall support all commonly used cross-manufacturer non-proprietary standard TTY signal protocols where the system interoperates with the Public Switched Telephone Network (PSTN)....
-
R306.3.2 Pedestrian Activated Signals
At roundabouts with multi-lane pedestrian street crossings, a pedestrian activated signal complying with R209 shall be provided for each multi-lane segment of each pedestrian street crossing...
-
4. Comparison of Proposed Technical Provisions Applicable to Shared Use Paths and AASHTO Guide
R302.5.3 Within Pedestrian Street Crossings....
- Cybex 625AT Arc Trainer - How to Use Demonstration Video
-
405.4 Floor or Ground Surfaces
Changes in level other than the running slope and cross slope are not permitted on ramp runs....
-
§1193.51(e) TTY signal compatibility
Products, including those providing voice communication functionality, shall support use of all cross-manufacturer non-proprietary standard signals used by TTYs....