Transfer supports shall comply with M305.2.
Search Results "Patient Seated in Wheelchair"
Commonly Searched Documents
-
M305.2 Transfer Supports
-
M305.2 Transfer Supports (Section-by-Section Analysis)
This is an introductory section. As discussed above in Section IV.E.1. (Significant Changes – Transfer Supports), the Access Board strengthened the transfer support requirements and...
-
5.4 Transfer Supports
5.4 Transfer Supports.
-
5.4 Transfer Supports Recommendations
5.4 Transfer Supports Recommendations
-
M305.2 Transfer Supports
Transfer supports shall comply with M305.2.
-
Amusement Rides with Wheelchair Spaces
Amusement Rides with Wheelchair Spaces Minimum space requirements and clearances for wheelchairs are specified where a ride provides a wheelchair space....
-
Preferred Seat Widths
The seat width percentiles remained the same for transfers to and from the station and within each protocol....
-
§382.131 Do baggage liability limits apply to mobility aids and other assistive devices?
With respect to transportation to which 14 CFR part 254 applies, the limits to liability for loss, damage, or delay concerning wheelchairs or other assistive devices provided in part 254...
-
Some wheelchairs weigh more than 600 pounds when occupied, and the design load of the lifts on our vehicles is 800 pounds. Is a transportation operator required to carry these “overweight” wheelchairs?
Transportation operators must carry a wheelchair and occupant if the lift and vehicle can physically accommodate them....
-
Battery-powered Wheelchairs
Battery-powered Wheelchairs Carriers must accept a passenger’s battery-powered wheelchair, including the battery, as checked baggage unless baggage compartment size and aircraft airworthiness...
-
1607A.8.2 Grab bars, shower seats and dressing room bench seats
1607A.8.2 Grab bars, shower seats and dressing room bench seats....
-
M301.2.3 Transfer Sides
The location of the Transfer Side will be located on the patient right or patient left at roughly midway between the foot end and head end....
- Tork Toilet Seat Cover Dispenser, 1/2 Fold
-
5.4.4.1 Transfer Support Distance from Transfer Surface for Stretchers
The horizontal distance from the transfer surface should be no more than 3 inches from the edge of the patient support surface....
-
Section 35.151(g) Assembly Areas (Section-by-Section Analysis)
The Department has become aware that a growing trend in the design of large sports facilities is to provide wheelchair seating on removable platforms that seat four or more wheelchair users...
- Gamco Surface Mounted Seat-Cover Dispenser - TSC-1
- Amos Winter: The cheap all-terrain wheelchair | TED Talks
-
382.129 What other requirements apply when passengers’ wheelchairs, other mobility aids, and other assistive devices must be disassembled for stowage?
382.129 What other requirements apply when passengers’ wheelchairs, other mobility aids, and other assistive devices must be disassembled for stowage?...
-
1607A.8.2 Grab bars, shower seats and dressing room bench seats
Grab bars, shower seats and dressing room bench seat systems shall be designed to resist a single concentrated load of 250 pounds (1.11 kN) applied in any direction at any point on the grab...
-
1607A.8.2 Grab bars, shower seats and dressing room bench seats
Grab bars, shower seats and dressing room bench seat systems shall be designed to resist a single concentrated load of 250 pounds (1.11 kN) applied in any direction at any point on the grab...
-
5.4.1.2 Transfer and Positioning Support Location Recommendations for Imaging Equipment with Transfer Surfaces
For wider tables, a transfer support would not be functional because of its distance from the patient....
- Acess-Able Designs Portable Tub/Shower Transfer Bench SH-425
-
4.16.3* Height
The height of water closets shall be 17 in to 19 in (430 mm to 485 mm), measured to the top of the toilet seat (see Fig. 29(b))....
-
4.16.3* HEIGHT
The height of water closets shall be 17 in to 19 in (430 mm to 485 mm), measured to the top of the toilet seat (see Fig. 29(b))....