The detectable warning shall extend the full width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum measured...
Search Results "Measuring Technique"
Filters
Commonly Searched Documents
-
406.8 Detectable Warnings
-
Intensity
Lamp intensity is given in effective candela (cd), measured in use at the source....
-
IV. Training and Technical Assistance from the United States
technical assistance to Harris County concerning the implementation of the terms of this Agreement, including assistance in preparing training materials and on ways to implement temporary measures...
-
§ 38.23(b)(8) Platform entrance ramp
The entrance ramp, or loading-edge barrier used as a ramp, shall not exceed a slope of 1:8, measured on level ground, for a maximum rise of 3 inches, and the transition from roadway or sidewalk...
-
Privacy: ADA Standard Section 707.4
., a covered entity does not have to take measures that would result in a fundamental alteration of its program or would cause undue burdens, provide adequate protection to operators of...
-
1015.2 Where required
Guards shall be located along open-sided walking surfaces, including mezzanines, equipment platforms, aisles, stairs, ramps and landings that are located more than 30 inches (762 mm) measured...
-
M301.2.1 Adjustability
Transfer surfaces shall be adjustable in height measured from the floor to the top of the uncompressed transfer surface and shall provide the following: A....
-
M302.2.1 Adjustability
Transfer surfaces shall be adjustable in height measured from the floor to the top of the uncompressed transfer surface and shall provide the following: A....
-
Floor Designations
The proposed rule specified that tactile floor designations at the hoistway be 60 inches above the floor, measured from the baseline of the characters (407.2.4)....
-
Accessible Pool Stairs
ADAAG provisions for stairs include the requirement that all steps have uniform riser heights and uniform tread widths of not less than 11 inches, measured from riser to riser....
-
§104.44(c) Course examinations
student's achievement in the course, rather than reflecting the student's impaired sensory, manual, or speaking skills (except where such skills are the factors that the test purports to measure...
-
7(2)(b)(vii)
If the shower stall is the only bathing facility provided in the covered dwelling unit, or on the accessible level of a covered multistory unit, and measures a nominal 36 x 36, the shower...
-
608.2.3 Alternate Roll-In Type Shower Compartments
Alternate roll-in type shower compartments shall be 36 inches (915 mm) wide and 60 inches (1525 mm) deep minimum clear inside dimensions measured at center points of opposing sides....
-
2 Method
The two main dependent measures were: Whether the detectable warnings could be seen from distances between 2.44 m (8ft) and 7.92 m (26 ft)....
-
903.4 Back Support
Back support shall be 2 1/2 inches (64 mm) maximum from the rear edge of the seat measured horizontally. ...
-
11B-604.7.1 Dispensers
Toilet paper dispensers shall comply with Section 11B-309.4 and shall be 7 inches (178 mm) minimum and 9 inches (229 mm) maximum in front of the water closet measured to the centerline of...
-
§ 38.125(b)(8) Platform entrance ramp
The entrance ramp, or loading-edge barrier used as a ramp, shall not exceed a slope of 1:8, when measured on level ground, for a maximum rise of 3 inches, and the transition from station...
-
§ 38.83(b)(8) Platform entrance ramp
The entrance ramp, or loading-edge barrier used as a ramp, shall not exceed a slope of 1:8 measured on level ground, for a maximum rise of 3 inches, and the transition from the station platform...
-
§ 38.95(b)(8) Platform entrance ramp
The entrance ramp, or loading-edge barrier used as a ramp, shall not exceed a slope of 1:8, when measured on level ground, for a maximum rise of 3 inches, and the transition from station...
-
11B-604.7.1 Dispensers
Toilet paper dispensers shall comply with Section 11B-309.4 and shall be 7 inches (178 mm) minimum and 9 inches (229 mm) maximum in front of the water closet measured to the centerline of...
-
Base Support [No specific provision—affects M303.2.4]
The footrest height data measures the height from the floor to the top surface of the footrest at its proximal outside corner....
-
A MINIMUM HIGHEST POINT STANDARD OF 19 INCHES IS CONSISTENT WITH EXISTING ACCESSIBILITY STANDARDS
The height of water closet seats shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum above the floor, measured to the top of the seat....
-
Bobrick Recessed Toilet Tissue Dispensers B-697
Double roll model measures 12 5⁄16" W x 6 1⁄8" H (315 x 155mm). Mounting: clamps for securing to stud walls or countertop aprons....
-
Bobrick Recessed Toilet Tissue Dispensers B-6977
Double roll model measures 12 5⁄16" W x 6 1⁄8" H (315 x 155mm). Mounting: clamps for securing to stud walls or countertop aprons....
