These utility tables can be 6 or 8 ft. long and offer 30" table height (nominal dimensions). ...
Search Results "Maximum Dimension"
Filters
Commonly Searched Documents
-
Pilot Rock APTX Full Sized Pedestal Rectangular Utility Tables Using Recycled Plastic
-
Side Wall: ADA Standard Section 604.5.1
Section 604.5.1 covers the current ADA Standards for side wall grab bars that are used for water closets.
-
Coat Hooks and Shelves: ADA Standard Section 803.5
Shelves shall be 40 inches (1015 mm) minimum and 48 inches (1220 mm) maximum above the finish floor or ground....
-
11B-809.10.6.2 Slope
The slope of the shower floor shall be 1/2 inch (12.7 mm) per foot maximum in any direction and shall slope to a drain....
-
11B-809.8.4 Door signal devices
The activating mechanism shall be mounted 48 inches (1219 mm) maximum above the floor and connected to permanent wiring....
-
BEA's MS21 Touchless Activation Sensor
The MS21 is made from stainless steel and includes a backlit LED plate for maximum visibility. Adjustable settings enable the users to create visual and audible detection alerts....
-
Door King Inc. 1150 Overhead Gate and Door opener
Specifications: Maximum gate height up to 14-feet*. (*Dependant on the rail assembly ordered). Maximum gate width 25-feet*. ...
-
Door King Inc. 9100 Slide Gate Operator Residential & Commercial
Specifications: Maximum gate length 30-feet. Maximum gate weight 1000 pounds*. (*Assumes gate is on level ground, in good condition with properly adjusted hardware. ...
-
Wagner Instruments Mark-10 M4 Digital Force Gauge
Analysis Accuracy: ± 0.2% of Full Scale Features Large graphic liquid crystal display of: Primary force reading - 6 digit Peak force readings - maximum...
-
4.3.7 Clear Floor Space for Reaching
4.3.7 Clear Floor Space for Reaching Clear floor space dimensions for reaching are different than for seating because they require a specific orientation to the target....
-
Wheelchair Spaces (M303.2)
This dimension is based on provisions in the 2004 ADA and ABA Accessibility Guidelines for maneuvering clearance where a clear floor or ground space is confined on all or part of three sides...
-
11B-1009.6.1 Pool stairs
Exception: Pool step riser heights shall not be required to be 4 inches (102 mm) high minimum and 7 inches (178 mm) high maximum provided that riser heights are uniform....
-
11B-604.9 Water closets and toilet compartments for children's use
TABLE 11B-604.9 SUGGESTED DIMENSIONS FOR CHILDREN’S USE SUGGESTED DIMENSIONS FOR WATER CLOSETS SERVING CHILDREN AGES 3 THROUGH 12 Ages...
-
Toilet Compartment Access
So it is still a latch side approach with exactly the same dimensions, including minimum clearances. I'm assuming that we are looking at compliance with the 2010 ADA Standards. ...
-
608.2.1 Transfer Type Shower Compartments
Transfer type shower compartments shall be 36 inches (915 mm) by 36 inches (915 mm) clear inside dimensions measured at the center points of opposing sides and shall have a 36 inch (915...
-
Urinal Depth
In the proposed rule, the Board sought to clarify the requirement in the original ADAAG that accessible urinals have an "elongated" rim by specifying a minimum dimension of 13 ½ inches,...
-
4.10.3 Hall Call Buttons
Call buttons shall be a minimum of 3/4 in (19 mm) in the smallest dimension. The button designating the up direction shall be on top. (See Fig. 20.) Buttons shall be raised or flush....
-
4.10.3 HALL CALL BUTTONS
Call buttons shall be a minimum of 3/4 in (19 mm) in the smallest dimension. The button designating the up direction shall be on top (see Fig. 20). Buttons shall be raised or flush....
-
Size and Clearances [4.21.2]
The 36 by 36 inch dimension, measured to the interior finish, keeps front and side grab bars within reach from the seat....
-
11B-404.2.9 Door and gate opening force
The force for pushing or pulling open a door or gate other than fire doors shall be as follows: Interior hinged doors and gates: 5 pounds (22.2 N) maximum....
-
Boarding Pier Clearances: ADA Standard Section 1003.3.2
Every 10 feet (3050 mm) maximum of linear pier edge shall contain at least one continuous clear opening 60 inches (1525 mm) wide minimum. EXCEPTIONS: 1....
-
Opening Force
No maximum opening force was proposed for exterior hinged doors....
-
Handrail Gripping Surfaces: ADA Standard Section 1008.2.5.3.1
Handrail gripping surfaces with a circular cross section shall have an outside diameter of 0.95 inch (24 mm) minimum and 1.55 inches (39 mm) maximum....
-
11B-1008.2.5.3.1 Handrail gripping surfaces
Handrail gripping surfaces with a circular cross section shall have an outside diameter of 0.95 inch (24 mm) minimum and 1.55 inches (39 mm) maximum....
