Search Results "Hybrid Surface System"
Filters
Commonly Searched Documents
-
Figure 302.3 Elongated Openings in Floor or Ground Surfaces – Drawing from the U.S. Access Board
-
1.1.3
1.1.3 A maximum overall design running slope for exterior accessible surfaces (other than ramps), such as sidewalks, of 4% (approximately 1:25) is recommended....
-
17. Can broken or older ground level play components be replaced without changing the surface?
Can broken or older ground level play components be replaced without changing the surface? Yes....
-
§ 38.87(a)
(a) Each vehicle shall be equipped with an interior public address system permitting transportation system personnel, or recorded or digitized human speech messages, to announce stations...
-
11B-606.5 Exposed pipes and surfaces
11B-606.5 Exposed pipes and surfaces. Water supply and drain pipes under lavatories and sinks shall be insulated or otherwise configured to protect against contact....
-
Firmness
The degree of surface resistance to deformation, especially by indentation or the movement of objects (U.S. Access Board, 2007)....
-
Listen Technologies Advanced Intelligent DSP RF Receiver 6-Pack
Ideal for venues to upgrade an existing 72 MHz assistive listening systems or expand an iDSP Advanced System with six iDSP units. ...
-
11B-219.3 Receivers
Receivers complying with 706.2 shall be provided for assistive listening systems in each assembly area in accordance with Table 219.3....
-
Inpro Corporation JointMaster® 787 Series Floor Expansion Joint Covers
The integral, high durometer seal of the 787 deters water from entering the system and acts as a noise dampening device....
-
Sargent NB8700 Top Latch Surface Vertical Rod Exit Device
Surface Vertical Rod Less Bottom Rod Exit Device is for both rated and non-rated openings....
-
Inpro Corporation JointMaster® 441 Series-Recessed Mount Expansion Joint
The 441 is a highly modifiable system with varying thicknesses of aluminum or stainless steel cover plates that can meet many project’s loading requirements....
-
702 Fire Alarm Systems
[See subsections ...]
-
702 Fire Alarm Systems
[See subsections ...]
-
Stable
A surface is not permanently affected by expected weather conditions and can sustain normal wear and tear from the expected use(s) of the area, between planned maintenance....
-
907.5.2.3.2 Groups R-1 and R-2.1
Visible alarms shall be activated by the in-room smoke alarm and the building fire alarm system....
-
11B-215.1 General
Where fire alarm systems and carbon monoxide alarm systems provide audible alarm coverage, alarms shall comply with Section 11B-215. [2010 ADA Standards] 215.1 General....
-
AccessRec AccessMat Beach Access Mat System
government and non-profit organizations officials, as well as any individual willing to increase accessibility to their beaches should consider providing our AccessMat™ Beach Access Mat system...
-
A4.28.3 VISUAL ALARMS
The specifications in this section do not preclude the use of zoned or coded alarm systems....
-
A. Visual Display Systems
Visual Display Systems. Announcements may be provided in a visual format by the use of electronic message boards or video monitors....
-
1009.8 Two-way communication
Exceptions: Two-way communication systems are not required at the landing serving each elevator or bank of elevators where the two-way communication system is provided within areas...
-
Analysis of Transfer Surface Dimensions Based on Wheeled Mobility User Anthropometry
Access Board RE: Analysis of Transfer Surface Dimensions Based on Wheeled Mobility User Anthropometry...
-
2) Where the Standard says "Changes in level are not permitted"
permitted", such as 304.2 for turning spaces: Here the standard is followed by an unenforceable advisory that says, "As used in this section, the phrase ‘changes in level’ refers to surfaces...
-
E. Level Surface
Are the level surfaces of accessible parking spaces and access aisles free of "built-up" curb ramps so persons who use mobility aids (e.g.: wheelchairs, walkers or crutches) can make convenient...
-
5.2.2.2 Transfer Surface Depth
5.2.2.2 Transfer Surface Depth. The transfer surface should be 17 inches deep minimum for equipment used by patients in a seated position....
