Elongated openings shall be placed so that the long dimension is perpendicular to the dominant direction of travel....
Search Results "Dimension Range"
-
11B-302.3 Openings
-
Chapter 6: Plumbing Elements and Facilities
Alternate specifications are provided for plumbing elements designed for children’s use as exceptions to requirements based on adult dimensions....
-
1. Measuring Tape
You will generally not need to measure dimensions in increments of less than ¼ inch....
-
5.4.2.1 Transfer Support Length Recommendation for Stretchers
5.4.2.1 Transfer Support Length Recommendation for Stretchers On Stretchers, the transfer surface is oriented along the long dimension of the surface on which patients are positioned...
-
5.4.4.2 Transfer Support Distance from Transfer Surface Recommendation for Imaging Equipment
Rationale for the Recommendation The Committee decided to follow the recommended 1 1/2inch proposal but included a 3-inch dimension to accommodate movement of the support....
-
Openings in Beach Access Routes
Place elongated openings more than a quarter of an inch wide with the long dimension perpendicular or diagonal to the primary direction of travel (see figure 44)....
-
Openings in Outdoor Recreation Access Route Surfaces
Place elongated openings that are more than a quarter of an inch wide with the long dimension perpendicular or diagonal to the primary direction of travel (figure 44)....
-
Knee Clearance: Clearance as Measured from Anterior-Most Point - Manual Wheelchair
It references dimensions of clearance height and depth to the forward-most point on the person or mobility device (e.g., toe, footrest)....
-
Knee Clearance: Clearance as Measured from Dorsal Foot Point - Manual Wheelchair
It references dimensions of clearance height and depth to the dorsal foot point on a person (e.g., top of ankle)....
-
1.2.1
1.2.1 Use the plus - or - minus symbol (±) after a dimension when it must be made clear what the expected tolerance is. This should be coordinated with the specification requirements....
-
11B-407.4.7.2 Keypads
The dot shall be 0.118 inch (3 mm) to 0.120 inch (3.05 mm) base diameter and in other aspects comply with Table 11B-703.3.1 _|Braille Dimensions|_....
-
Example 2: Without Cooking Facilities
An employee break room without fixed or built-in range cooking facilities is not considered a kitchen or kitchenette; therefore, they are not subject to compliance with the requirements...
-
a. Transfer Surface Adjustability
The MDE NPRM proposed that the same transfer surface height range of 17 inches minimum to 19 inches maximum be applied to both diagnostic equipment used in the supine, prone, or side-lying...
-
11B-227.4 Food service lines
Where self-service shelves are provided, at least 50 percent, but no fewer than one, of each type provided shall comply with Section 11B-308 _|Reach Ranges|_. ...
-
606.1 General
If soap and towel dispensers are provided, they must be located within the reach ranges specified in 308....
-
803.5 Coat Hooks and Shelves
Coat hooks provided within the room shall be located within one of the reach ranges specified in 308....
-
606.1 General
If soap and towel dispensers are provided, they must be located within the reach ranges specified in 308....
-
11B-227.4 Food service lines
Where self-service shelves are provided, at least 50 percent, but no fewer than one, of each type provided shall comply with Section 11B-308 _|Reach Ranges|_. ...
-
Guidelines for Requirement 7
The Department has eliminated the specification that controls for ranges and cooktops be placed so that reaching across burners is not required....
-
Mounting Height and Location
The proposed rule specified a range of height of 48 to 60 inches for raised characters and a range of 40 to 60 inches for braille....
-
Protrusion Limits: ADA Standard Section 307.2
Section 307.2 covers the current ADA Standards for protrusion limits.
-
Height: ADA Standard Section 704.4.1
the required 34 inches (865 mm) minimum keypad height can causes the highest operable part of the telephone, usually the coin slot, to exceed the maximum permitted side and forward reach ranges...
-
11B-809.9.2 Clear width
U-shaped kitchens, designed with parallel approach at a sink, range, cooktop or other fixtures and appliances located at the base of the U without knee and toe clearance, shall provide a...
-
11B-307.2 Protrusion limits
When a cane is used and the element is in the detectable range, it gives a person sufficient time to detect the element with the cane before there is body contact....