A full benefit-cost analysis is required of any regulatory action that is deemed to be significant--that is, a regulation that will have an annual effect of $100 million or more on the economy...
Search Results "Full Length Mirror"
Filters
Commonly Searched Documents
-
Regulatory Impact Analysis.
-
Vehicle Parking
Even when conditions for exception are numerous and extreme, at least 20 percent of parking areas must be full width....
-
1017.1 General
When an entity determines that a condition in 1019 does not permit full compliance with a specific provision in 1017 on a portion of a trail, the portion of the trail shall comply with the...
-
Section 35.151 New Construction and Alterations (Section-by-Section Analysis)
The Department will add a new section, designated as § 35.151(a)(2), to provide that full compliance with the requirements of this section is not required where an entity can demonstrate...
-
1017.1 General
When an entity determines that a condition in 1019 does not permit full compliance with a specific provision in 1017 on a portion of a trail, the portion of the trail shall comply with the...
-
Section 37.71 Purchase or Lease of New Non-Rail Vehicles by Public Entities Operating Fixed Route Systems
The public entity also must include a full justification for the assertion that a delay in the bus procurement sufficient to obtain a lift-equipped bus would significantly impair transportation...
-
Can you upgrade/expand an existing location without adhering to ADA standards?
The new accessibility requirements in the CBC are intended to provide full compliance with the requirements of the ADA....
-
§100.201a(a)
(a) The following standards are incorporated by reference into 24 CFR part 100 pursuant to 5 U.S.C. 552(a) and 1 CFR part 51, as though set forth in full....
-
5.1.6 Clear Floor or Ground Space
One full unobstructed side of the clear ground space shall adjoin or overlap the trail or ORAR, as applicable, or another clear ground space....
-
§ 37.139(d)(5)
In no case may full implementation be completed later than January 26, 1997....
-
What kinds of securement equipment must be provided in buses and vans?
Section 38.23(a) requires vehicles over 22 feet in length to have enough securement locations and devices to secure two wheelchairs, while vehicles 22 feet and under must be able to accommodate...
-
What kinds of securement equipment must be provided in buses and vans?
Section 38.23(a) requires vehicles over 22 feet in length to have enough securement locations and devices to secure two wheelchairs, while vehicles 22 feet and under must be able to accommodate...
-
11B-505.2 Where required
At door landings, handrails are not required when the ramp run is less than 6 inches (152 mm) in rise or 72 inches (1829 mm) in length....
-
A7. Curb Ramps
[ADA Stds 4.7.2] Note: 1:12 is one inch of vertical height for each 12 inches in length. Yes _____ No _____...
-
A4.8.2 Slope and Rise
The ability to manage an incline is related to both its slope and its length....
-
Handrail Clearance and Cross Section [§505.5, §505.7]
Handrail Clearance and Cross Section [§505.5, §505.7] Surface requirements and clearances facilitate a power grip along the length of handrails....
-
11B-812.7.2 Marking
Access aisle markings may extend beyond the minimum required length....
-
11B-505.2 Where required
At door landings, handrails are not required when the ramp run is less than 6 inches (152 mm) in rise or 72 inches (1829 mm) in length....
-
11B-403.7 Continuous gradient
All walks with continuous gradients shall have resting areas, 60 inches (1524 mm) in length, at intervals of 400 feet (121,920 mm) maximum....
-
11B-403.7 Continuous gradient
All walks with continuous gradients shall have resting areas, 60 inches (1524 mm) in length, at intervals of 400 feet (121,920 mm) maximum....
-
General: ADA Standard Section 205.1
Section 205.1 of the ADA Standards covers information on scoping requirements for operable parts in the most current ADA Standards.
-
11B-407.2.3.1 Floor designation
The outside diameter of the star shall be 2 inches (51 mm) and all points shall be of equal length. Raised characters, including the star, shall be white on a black background....
-
11B-1007.2 Accessible routes
Ramp landing length specified by Section 11B-405.7.3 shall be permitted to be 48 inches (1219 mm) long minimum....
-
225.2.1 Lockers
Different types of lockers may include full-size and half-size lockers, as well as those specifically designed for storage of various sports equipment....