Operable parts shall be located so that they are reachable by passengers using wheelchair when parked in a clear space 30 inches (760 mm) wide minimum and 48 inches (1220 mm) long minimum...
Search Results "Door Operator"
Commonly Searched Documents
-
T505.3 Location of Operable Parts
-
302.6 Without Speech
Where speech is used for input, control, or operation, ICT shall provide at least one mode of operation that does not require user speech....
-
11B-404.3.6 Break out opening
Where doors and gates without standby power are a part of a means of egress, the clear break out opening at swinging or sliding doors and gates shall be 32 inches (813 mm) minimum when operated...
-
404.3.6 Break Out Opening
Where doors and gates without standby power are a part of a means of egress, the clear break out opening at swinging or sliding doors and gates shall be 32 inches (815 mm) minimum when operated...
-
11B-404.3.6 Break out opening
Where doors and gates without standby power are a part of a means of egress, the clear break out opening at swinging or sliding doors and gates shall be 32 inches (813 mm) minimum when operated...
-
11B-404.3.6 Break out opening
Where doors and gates without standby power are a part of a means of egress, the clear break out opening at swinging or sliding doors and gates shall be 32 inches (813 mm) minimum when operated...
- Visitability
-
Paragraph (i) (Advisory Guidance)
Paragraph (i) Operable with Limited Cognitive Skills 1. Many individuals have reduced cognitive abilities, including reduced memory, sequence tracking, and reading skills....
-
(3) Doors within individual dwelling units
The final Guidelines recommend that doors intended for user passage within individual dwelling units have a clear opening of at least 32 inches nominal width when the door is open 90 degrees...
-
Minimum Clear Opening
The issue of minimum clear opening for doors was one of the most widely commented-upon design features of the guidelines....
-
M307 Operable Parts
[See subsections ...]
-
M307 Operable Parts
[See subsections ...]
-
11B-604.8.1.1.1 Maneuvering space with in-swinging door
11B-604.8.1.1.1 Maneuvering space with in-swinging door....
-
4.1.3(7)(c)
(c) Each door that is an element of an accessible route shall comply with 4.13....
-
4.1.3(7)(d)
(d) Each door required by 4.3.10, Egress, shall comply with 4.13....
-
Car Dimensions: ADA Standard Section 407.4.1
Section 407.4.1 covers the current ADA Standards for elevator car dimensions.
-
Can maneuvering for a forward approach be provided when there is space at least 60” deep in front of a door?
Space at least 60” deep in front of a door that is unobstructed on approach sides will provide sufficient depth for a forward approach if appropriate strike-side clearance is provided; but...
-
Trash and Recycling Receptacles [1011.2 and 1011.3]
The operable parts of trash and recycling containers, such as handles or latches, must be between 15 and 48 inches above the ground....
-
4.1.3(7)(b)
(b) Within a building or facility, at least one door at each accessible space shall comply with 4.13....
- Wagner Instruments Chatillon® DFE Digital Force Gauge
- Doug Mockett & Company SDH1 Sliding Door Hardware
-
302.6 Without Speech (Section-by-Section Analysis)
Analysis) This proposed section would clarify the requirements in existing 508 Standards §1194.31(e) and existing 255 Guidelines §1193.41(h) by specifying that provision of a mode of operation...
-
302.7 With Limited Manipulation (Section-by-Section Analysis)
The provision would require that, when ICT provides a manual mode of operation, it must also provide at least one mode of operation that does not require fine motor control or operation...
-
Toilet Compartment Access
If the door and access were from the opposite side, although not as accessible I believe it is also §404 compliant because a self-closing door is not the same as a door with a closer? ...