11B-609.5 Surface hazards. Grab bars and any wall or other surfaces adjacent to grab bars shall be free of sharp or abrasive elements and shall have rounded edges....
Search Results "Ramp Surface"
-
11B-609.5 Surface hazards
-
Aluminum Flush Top SGF Series Pressure-Locked Grating
This series offers a type of pressure locked grating in which the cross bars are in the same plane relative to the top surface of the grating....
-
11B-812.3 Floor or ground surfaces
Vehicle spaces and access aisles serving them shall comply with Section 11B-302. Access aisles shall be at the same level as the vehicle space they serve. Changes in level, slopes...
-
11B-812.3 Floor or ground surfaces
Vehicle spaces and access aisles serving them shall comply with Section 11B-302. Access aisles shall be at the same level as the vehicle space they serve. Changes in level, slopes...
-
Slope Meters and Levels
Corada has reviewed several models of slope meters and levels to assist accessibility surveyors in measuring slope and level changes. The following are the models that can be...
-
Transfer Surface
Part of diagnostic equipment onto which patients who use mobility devices or aids transfer when moving onto and off of the equipment.
-
Transfer Surface
Part of diagnostic equipment onto which patients who use mobility devices or aids transfer when moving onto and off of the equipment.
-
T602.2 Surfaces
Wheelchair space surfaces shall comply with T302....
-
Figure 505.4 Handrail Height – Drawing from the U.S. Access Board
-
General: ADA Standard Section 902.1
Dining surfaces and work surfaces shall comply with 902.2 and 902.3. EXCEPTION: Dining surfaces and work surfaces for children’s use shall be permitted to comply with 902.4....
-
1011.2.2 Surface
This section requires the surface of the clear ground space to be firm and stable....
-
F226 Dining Surfaces and Work Surfaces
[See subsections ...]
-
902 Dining Surfaces and Work Surfaces
[See subsections ...]
-
226 Dining Surfaces and Work Surfaces
[See subsections ...]
-
902 Dining Surfaces and Work Surfaces
[See subsections ...]
-
Sec.36.304(e) Portable ramps
(e) Portable ramps. Portable ramps should be used to comply with this section only when installation of a permanent ramp is not readily achievable....
-
§ 38.23(c)(7) Stowage
A compartment, securement system, or other appropriate method shall be provided to ensure that stowed ramps, including portable ramps stowed in the passenger area, do not impinge on a passenger's...
-
405.8 Handrails
Ramp runs with a rise greater than 6 inches (150 mm) shall have handrails complying with 505....
-
405.8 Handrails
Ramp runs with a rise greater than 6 inches (150 mm) shall have handrails complying with 505....
-
Running Slope of Ramps Deployed to Roadways or Curb-Height Bus Stops
However, the text of the final rule has been revised to make clear that the requisite maximum running slope is a design standard to be measured to ground level with the bus on a flat surface...
-
405.8 Handrails
Ramp runs with a rise greater than 6 inches (150 mm) shall have handrails complying with 505....
-
Scoping [4.1.2(4), 4.1.3(3)]
Requirements in 4.5 apply to accessible routes and spaces, including ramps, elevators, platform lifts, and clear floor space....
-
T402 Ramps and Bridgeplates
[See subsections ...]
-
11B-1008.2.5.3.1 Handrail gripping surfaces
Handrail gripping surfaces with a circular cross section shall have an outside diameter of 0.95 inch (24 mm) minimum and 1.55 inches (39 mm) maximum....
