Corada has reviewed several models of slope meters and levels to assist accessibility surveyors in measuring slope and level changes. The following are the models that can be...
Search Results "Ramp Surface"
-
Slope Meters and Levels
-
Transfer Surface
Part of diagnostic equipment onto which patients who use mobility devices or aids transfer when moving onto and off of the equipment.
-
Transfer Surface
Part of diagnostic equipment onto which patients who use mobility devices or aids transfer when moving onto and off of the equipment.
-
T602.2 Surfaces
Wheelchair space surfaces shall comply with T302....
-
Figure 505.4 Handrail Height – Drawing from the U.S. Access Board
-
General: ADA Standard Section 902.1
Dining surfaces and work surfaces shall comply with 902.2 and 902.3. EXCEPTION: Dining surfaces and work surfaces for children’s use shall be permitted to comply with 902.4....
-
1011.2.2 Surface
This section requires the surface of the clear ground space to be firm and stable....
-
F226 Dining Surfaces and Work Surfaces
[See subsections ...]
-
902 Dining Surfaces and Work Surfaces
[See subsections ...]
-
226 Dining Surfaces and Work Surfaces
[See subsections ...]
-
902 Dining Surfaces and Work Surfaces
[See subsections ...]
-
Sec.36.304(e) Portable ramps
(e) Portable ramps. Portable ramps should be used to comply with this section only when installation of a permanent ramp is not readily achievable....
-
§ 38.23(c)(7) Stowage
A compartment, securement system, or other appropriate method shall be provided to ensure that stowed ramps, including portable ramps stowed in the passenger area, do not impinge on a passenger's...
-
405.8 Handrails
Ramp runs with a rise greater than 6 inches (150 mm) shall have handrails complying with 505....
-
405.8 Handrails
Ramp runs with a rise greater than 6 inches (150 mm) shall have handrails complying with 505....
-
Running Slope of Ramps Deployed to Roadways or Curb-Height Bus Stops
However, the text of the final rule has been revised to make clear that the requisite maximum running slope is a design standard to be measured to ground level with the bus on a flat surface...
-
405.8 Handrails
Ramp runs with a rise greater than 6 inches (150 mm) shall have handrails complying with 505....
-
Scoping [4.1.2(4), 4.1.3(3)]
Requirements in 4.5 apply to accessible routes and spaces, including ramps, elevators, platform lifts, and clear floor space....
-
T402 Ramps and Bridgeplates
[See subsections ...]
-
11B-1008.2.5.3.1 Handrail gripping surfaces
Handrail gripping surfaces with a circular cross section shall have an outside diameter of 0.95 inch (24 mm) minimum and 1.55 inches (39 mm) maximum....
-
11B-1008.2.5.3.1 Handrail gripping surfaces
Handrail gripping surfaces with a circular cross section shall have an outside diameter of 0.95 inch (24 mm) minimum and 1.55 inches (39 mm) maximum....
-
§ 38.159(c) Vehicle ramp
(c) Vehicle ramp—...
-
11B-505.3 Continuity
Handrails shall be continuous within the full length of each stair flight or ramp run....
