Beach access routes are required when the entity that administers or manages the beach undertakes a beach nourishment project. The entity is not required to spend more than 20...
Search Results "Side Grab Bar"
Filters
Commonly Searched Documents
-
Beach Nourishment [F248.1.2]
-
Openings [1018.6]
Openings are gaps in the surface of a beach access route. Gaps, including spaces between the planks on a boardwalk and drainage holes in temporary or permanent surfaces, that are...
-
1018.7 Slopes
This section contains technical requirements for the maximum running slope and segment length (1018.7.1) and cross slope (1018.7.2) of beach access routes.
-
Openings in Beach Access Routes
Openings are gaps in the surface of a beach access route. Gaps include spaces between the planks on a boardwalk and drainage holes in temporary or permanent surfaces. Openings that...
-
6.7 Slope
The slopes of beach access routes shall comply with 6.7.1 and 6.7.2
-
6.10 Openings
Openings in the surface of beach access routes and their related resting intervals may be up to 1/2 inch (13 millimeters) wide. Where possible, elongated openings should be...
-
6.14 Gates and Barriers
Where gates or barriers are constructed to control access to beach access routes, gates and barriers shall comply with 6.14.
-
6.7.1.1
The grade of a Beach Access Route shall be 1:20 (5 percent) or less for any distance.
-
Beach Nourishment
A process by which sediment (usually sand) is added to a beach. An entity is not required to expend more than 20% of the costs of a beach nourishment project to provide a beach...
-
6.7.1 Running Slope (Grade)
The running slope (grade) of a Beach Access Route shall comply with all applicable provisions of this section. Table 6.7.1. Running Slope (Grade) and Resting...
-
1018.7 Slopes
The slopes of beach access routes shall comply with 1018.7.
-
1018.6 Openings
Openings in the surface of beach access routes and resting intervals shall not allow the passage of a sphere more than 1/2 inch (13 mm) in diameter. Advisory 1018.6 Openings....
-
F248.1 General
Beach access routes complying with 1018 shall be provided in accordance with F248.1. Beach access routes shall be permanent or removable. EXCEPTION: Beach access routes shall not...
-
Figure 404.2.4.1(b) Maneuvering Clearances at Manual Swinging Doors and Gates: Front Approach, Push Side – Drawing from the U.S. Access Board
-
Plan 4B: 13-Foot Wide Accessible Guest Room
Alternate roll-in shower has a 36-inch wide entry at one end of the long end of the compartment (section 608.2.3); • Recessed alternate roll-in shower location permits shorter rear grab...
-
Plan 3B: 12-Foot Wide Accessible Guest Room
Comparable vanity counter top space (section 806); • Standard roll-in type shower with folding seat (section 608.2.2); • Recessed lavatory with vanity counter top permits shorter rear grab...
-
California Water Closet Accessories
Design guidance for locating water closet accessories in single user toilet rooms and best practice placement of the lavatory in new construction giving the owner more options to...
-
Figure 404.2.4.1(c) Maneuvering Clearances at Manual Swinging Doors and Gates: Front Approach, Push Side with Closer and Latch – Drawing from the U.S. Access Board
-
406.5 Location
Curb ramps and the flared sides of curb ramps shall be located so that they do not project into vehicular traffic lanes, parking spaces, or parking access aisles....
-
11B-406.5.10 Diagonal curb ramps
Diagonal curb ramps with flared sides shall have a segment of curb 24 inches (610 mm) long minimum located on each side of the curb ramp and within the marked crossing....
-
1607.9 Loads on handrails, guards, grab bars, shower seats, dressing room bench and seats
1607.9 Loads on handrails, guards, grab bars, shower seats, dressing room bench and seats....
-
11B-406.5.10 Diagonal curb ramps
Diagonal curb ramps with flared sides shall have a segment of curb 24 inches (610 mm) long minimum located on each side of the curb ramp and within the marked crossing....
-
M301 Diagnostic Equipment Used by Patients in Supine, Prone, or Side-Lying Position; M302 Diagnostic Equipment Used by Patients in Seated Position
M301 provides technical criteria for diagnostic equipment used by patients in a supine, prone, or sidelying position, and M302 provides technical criteria for diagnostic equipment used by...
-
M302.2.5 Unobstructed Transfer (Section-by-Section Analysis)
In the MDE NPRM the Access Board proposed that each transfer side provide unobstructed access to the transfer surface, with an exception to permit temporary obstructions as long as they...
