Refer to CCR Title 24, Part 12, Chapter 11B, Section 12-11B.205 for building and facility access specifications for product approval for detectable warning products and directional surfaces...
Search Results "Section 504"
-
11B-705.3 Product Approval
-
11B-809.9.4 Work surfaces
Work surfaces shall be 36 inches (914 mm) maximum above the finish floor with minimum lengths at the following locations as required by this section: Linear length of 30 inches...
-
11B-404.2.5 Thresholds
Raised thresholds and changes in level at doorways shall comply with Sections 11B-302 and 11B-303. Exception: Reserved....
-
11B-502.1 General
Car and van parking spaces shall comply with Section 11B-502....
-
11B-605.4 Flush controls
Hand operated flush controls shall comply with Section 11B-309 except that the flush control shall be mounted at a maximum height of 44 inches (1118 mm) above the finish floor....
-
11B-809.9.1 Clear floor space
For a parallel or forward approach to the sink and to the work surface required by Sections 11B-809.9.3 and 11B-809.9.4....
-
1.1.10 Availability of codes
Each state department concerned and each city, county or city and county shall have an up-to-date copy of the code available for public inspection, See Health and Safety Code Section 18942...
-
802.1.5 Overlap
The term "circulation paths" used in Section 802.1.5 means aisle width required by applicable building or life safety codes for the specific assembly occupancy....
-
208.1 General
See section 502.5 requirements for van parking in structures....
-
DISABILITY
(a)(1)(i) of this section, the “record of” prong in paragraph (a)(1)(ii) of this section, or the “regarded as” prong in paragraph (a)(1)(iii) of this section....
-
I. Need For and Final Objectives of the Guidelines.
The Access Board is responsible for developing accessibility guidelines in conjunction with the Federal Communications Commission (FCC) under section 255(e) of the Telecommunications Act...
-
Escalators
The ASME code requires steps to be demarcated by yellow lines 2 inches wide maximum along the back and sides of steps (ASME A17.1, section 6.1.3.5.6)....
-
Vanity Counter Tops
The proposed rule also applied requirements for reach ranges and operable parts (sections 308 and 309) which would have effectively required knee and toe clearances below the vanities....
-
Scoping Requirements for Elevators
Scoping requirements for elevators in section 206.6 reference technical criteria for standard passenger elevators, destination-oriented elevators, existing elevators that are altered, limited-use...
-
11B-407.2.3.1 Floor designation
Floor designations complying with Sections 11B-703.2 and 11B-703.4.1 shall be provided on both jambs of elevator hoistway entrances....
-
Contrast
However, requirements for ground and floor surfaces in section 302, which require slip resistance, apply to those surfaces with detectable warnings as well....
-
Location of Accessible Parking Spaces
Section 208.3 specifies the location of accessible parking spaces....
-
Two-Way Communication
Section 407.4.9 provides criteria for emergency two-way communication systems in elevator cars which address the height of operable parts and identification by tactile characters....
-
1115B.3.1, Item 5
SECTION 1115B BATHING AND TOILET FACILITIES (SANITARY FACILITIES) 1115B.3 Toilet facilities. 1115B.3.1 Multiple-accommodation toilet facilities. See Figure 11B-1B....
-
711.3.2 Membrane penetrations
Membrane penetrations shall comply with Section 711.3.1....
-
Requirement 5. Light switches, electrical outlets, thermostats and other environmental controls in accessible locations.
Section 100.205(c)(3)(ii) requires that all covered multifamily dwellings with a building entrance on an accessible route shall be designed and constructed in such a manner that all premises...
-
1. Accessible route(s)
Accessible element or space ANSI A117.1 section APPLICATION 1....
-
T503 Passenger Access Routes
See 2010 NPRM, Section T502.2. For the reasons discussed previously, see Section III (Major Issues), the Board decided not to move forward with this proposal in the final rule....
-
D. Plain Language Instructions
Regular U.S. mail: Disability Rights Section, Civil Rights Division, U.S. Department of Justice, P.O. Box 2885, Fairfax, VA 22031-0885....