The handrail shall have a cross-sectional diameter between 11/4 inches (32 mm) and 11/2 inches (38 mm) or shall provide an equivalent grasping surface, and have eased edges with corner radii...
Search Results "Section 504"
2010 ADA Definition
Section 504: Section 504 means section 504 of the Rehabilitation Act of 1973 (Pub. L. 93-112, 87 Stat. 394 (29 U.S.C. 794), as amended.
Filters
Commonly Searched Documents
-
§ 38.159(c)(8) Handrails
-
11B-806.3 Guest rooms with communication features
Guest rooms required to provide communication features shall comply with Section 11B-806.3. [2010 ADAS] Advisory 806.3 Guest Rooms with Communication Features....
-
11B-308.1 General
Reach ranges shall comply with Section 11B-308. [2010 ADAS] Advisory 308.1 General. ...
-
11B-1009.2.1 Pool lift location
Where the entire pool depth is less than 36 inches (914 mm) or greater than 48 inches (1219 mm), compliance with Section 11B-1009.2.1 shall not be required. [2010 ADA Standards] 1. ...
-
101.4.5 Fire prevention
ETA Editor's Note Sections from the California Building Code Chapter 1 that are not adopted by the Division of the State Architect - Access Compliance (DSA-AC) have been omitted....
-
[2010 ADA Standards] 105.1 General
Architectural and Transportation Barriers Compliance Board, 1331 F Street, NW, Suite 1000, Washington, DC 20004; at the Department of Justice, Civil Rights Division, Disability Rights Section...
-
11B-1002.5 Amusement ride seats designed for transfer
Amusement ride seats designed for transfer shall comply with Section 11B-1002.5 when positioned for loading and unloading....
-
[ADA Title II §35.151(b)(4)(i)] Primary function
(B) For the purposes of this section, alterations to windows, hardware, controls, electrical outlets, and signage shall not be deemed to be alterations that affect the usability of or access...
-
11B-806.3 Guest rooms with communication features
Guest rooms required to provide communication features shall comply with Section 11B-806.3. Advisory 11B-806.3 Guest rooms with communication features....
-
11B-607.2 Clearance
A lavatory complying with Section 11B-606 shall be permitted at the control end of the clearance....
-
1133A.2.1 Clear width
U-shaped kitchens, designed with a cooktop or sink located at the base of the U, which provides a knee and toe space in accordance with Section 1133A.7 to allow for a forward approach, shall...
-
1.9.1.1.2
For public housing see Section 1.9.1.3. Advisory 1.9.1.1.2. Leases per se, unless alterations occur, do not directly “trigger” construction code requirements....
-
11B-703.4.1 Height above finish floor or ground
Exception: Tactile characters for elevator car controls shall not be required to comply with Section 11B-703.4.1....
-
11B-809.9.2 Clear width
U-shaped kitchens, with a cooktop, sink or work surface located at the base of the U, that provides knee and toe space complying Sections 11B-809.9.3 and 11B-809.9.4 to allow for a forward...
-
§ 382.35 Attendants
(a) Except as provided in this section, a carrier shall not require that a qualified individual with a disability travel with an attendant as a condition of being provided air transportation...
-
7.11(a) Collective Bargaining Agreements
One of those changes effects this section: IV....
-
11B-219.3 Receivers
Twenty-five percent minimum of receivers provided, but no fewer than two, shall be hearing-aid compatible in accordance with Section 11B-706.3. [2010 ADAS] 219.3 Receivers. ...
-
RECOMMENDED CHANGE
RECOMMENDED CHANGE Revise the Section 5.4.11 recommendation as follows: The Committee recommends transfer supports and connections contain the strength to resist vertical forces of...
-
Picnic Tables [1011.2 and 1011.4]
The wheelchair space must be positioned for a forward approach and provide knee and toe clearance under the table that complies with section 306 of the ABA Standards....
-
Table 2
The impacts are analyzed in the regulatory assessment and discussed below under Cross Slope (R302.6) in the Section-by-Section Analysis. 25The requirements analyzed in Table 2 include...
-
Step 3: Apply the Accessibility Provisions
This step involves looking at FSTAG, sections 7.4.1 through 7.4.8, which contain the technical requirements for trail grade, cross slope, resting interval, surface, clear tread width, passing...
-
3.2.2.2. Medium Accessibility Baseline
The Medium Accessibility baseline is used in the cost estimation for the primary analysis presented in Section 4.1. ...
-
Path Width
Section 4.2.1 of the ADAAG requires a minimum clear width of 0.815 m (32 inches) at a point, and 0.915 m (36 inches) continuously, for single wheelchair passage....
-
4.2.1. Low Accessibility Baseline
As described in Section 3.2.2.1, one of the alternative baselines is the Low Accessibility baseline, which is the most conservative option. ...