Section 303 addresses vertical changes in level in floor or ground surfaces. No changes have been made to this section....
Search Results "Vertical Reference Plane"
-
303 Changes in Level
-
11B-609.8 Structural strength
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the grab bar, fastener, mounting device,...
-
11B-903.6 Structural strength
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the seat, fastener, mounting device, or...
-
11B-307.4.1 Guy braces
Where a guy support is used within either the width of a circulation path or 24 inches maximum outside of a circulation path, a vertical guy brace, sidewalk guy or similar device shall be...
-
11B-307.4.1 Guy braces
Where a guy support is used within either the width of a circulation path or 24 inches maximum outside of a circulation path, a vertical guy brace, sidewalk guy or similar device shall be...
-
III-9.0000 CERTIFICATION
Regulatory references: 28 CFR 36.601-36.608....
-
III-4.0000 SPECIFIC REQUIREMENTS
Regulatory references: 28 CFR 36.301-36.310....
-
III-8.0000 ENFORCEMENT
Regulatory references: 28 CFR 36.501-36.508....
-
III-1.0000 COVERAGE
Regulatory references: 28 CFR 36.102-36.104....
-
III-3.0000 GENERAL REQUIREMENTS
Regulatory references: 28 CFR 36.201-36.213....
-
II-9.0000 INVESTIGATION OF COMPLAINTS AND ENFORCEMENT
Regulatory references: 28 CFR 35.170-35.190....
-
II-5.0000 PROGRAM ACCESSIBILITY
Regulatory references: 28 CFR 35.149-35.150...
-
II-7.0000 COMMUNICATIONS
Regulatory references: 28 CFR 35.160-35.164....
-
II-3.0000 GENERAL REQUIREMENTS
Regulatory references: 28 CFR 35.130-35.135....
-
Permanently Installed Systems
Vertical wheelchair lifts are differentiated from elevators because they are limited in the height of their vertical lift, are not enclosed, and do not go through a floor level....
-
11B-505.4 Height
Top of gripping surfaces of handrails shall be 34 inches (864 mm) minimum and 38 inches (965 mm) maximum vertically above walking surfaces, stair nosings, and ramp surfaces....
-
11B-505.4 Height
Top of gripping surfaces of handrails shall be 34 inches (864 mm) minimum and 38 inches (965 mm) maximum vertically above walking surfaces, stair nosings, and ramp surfaces....
-
505.4 Height
Top of gripping surfaces of handrails shall be 34 inches (865 mm) minimum and 38 inches (965 mm) maximum vertically above walking surfaces, stair nosings, and ramp surfaces....
-
III-4.2200 Specialties
It is not considered discriminatory for a public accommodation with a specialty in a particular area to refer an individual with a disability to a different public accommodation if --...
-
[2010 ADA Standards] 105.1 General
The standards listed in 105.2 are incorporated by reference in this document and are part of the requirements to the prescribed extent of each such reference....
-
Citation Generator: Create Accurate Citations in Seconds
This is especially useful for students working under tight deadlines and researchers managing large numbers of references. Accuracy is another important advantage....
-
MEANS OF EGRESS
A continuous and unobstructed path of vertical and horizontal egress travel from any occupied portion of a building or structure to a public way....
-
11B-602.5 Spout location
The spout shall be located 15 inches (381 mm) minimum from the vertical support and 5 inches (127 mm) maximum from the front edge of the unit, including bumpers. ...
-
Automatic Operation [4.10.2]
Self-leveling must correct the overtravel or undertravel of a car as it stops at a landing within a ½ inch vertical tolerance since changes in level greater than ½ inch can be troublesome...