(i) the unusual site characteristics result in a difference in finished grade elevation exceeding 30 inches and 10 percent measured between an entrance and all vehicular or pedestrian arrival...
Search Results "Mitigating Measures"
-
1(2)(b)(i)
-
11B-1002.4.4.1 Width and length
Wheelchair spaces shall provide a clear width of 30 inches (762 mm) minimum and a clear length of 48 inches (1219 mm) minimum measured to 9 inches (229 mm) minimum above the floor surface...
-
Are bollards, poles, columns, or other elements permitted within the marked area of access aisles?
(The width of spaces and aisles is measured to the centerline of markings but can include the full line width where there is no adjacent parking space or aisle)....
-
11B-1002.4.4.1 Width and length
Wheelchair spaces shall provide a clear width of 30 inches (762 mm) minimum and a clear length of 48 inches (1219 mm) minimum measured to 9 inches (229 mm) minimum above the floor surface...
-
§ 38.81(b)
(b) Other stepwells, and doorways with lifts, ramps or bridge plates, shall have, at all times, at least 2 foot-candles of illumination measured on the step tread or lift or ramp, when deployed...
-
11B-1002.4.4.1 Width and length
Wheelchair spaces shall provide a clear width of 30 inches (762 mm) minimum and a clear length of 48 inches (1219 mm) minimum measured to 9 inches (229 mm) minimum above the floor surface...
-
1009.2.4 Seat Height
The height of the lift seat shall be designed to allow a stop at 16 inches (405 mm) minimum to 19 inches (485 mm) maximum measured from the deck to the top of the seat surface when in the...
-
1002.4.4.1 Width and Length
Wheelchair spaces shall provide a clear width of 30 inches (760 mm) minimum and a clear length of 48 inches (1220 mm) minimum measured to 9 inches (230 mm) minimum above the floor surface...
-
Just Manufacturing Automatic Soap Dispenser
Pre-measured dispensing volume (1-1.5ml). Reservoir capacity 900ml - refillable. Sensor detection range adjustable....
-
Seton Parking Signs - Van Accessible with ISA
.063" Engineer Grade reflective aluminum to improve sign visibility at night Extend the life and performance of the sign by upgrading to Seton UltraTuff™ overlaminate Sign measures...
-
Seton Parking Signs - Blue Reserved Parking with ISA
.063" Engineer Grade reflective aluminum to improve sign visibility at night Extend the life and performance of the sign by upgrading to Seton UltraTuff™ overlaminate Sign measures...
-
Inclusion Solutions Blue Parking Stop
Steel installation anchors included Measures 72"L x 4"H x 6"W Weighs 30 lbs....
-
Section 36.304 Removal of Barriers (Section-By-Section Analysis and Response to Comments)
available for barrier removal may not be adequate to remove all existing barriers at any given time, Sec.36.304(c) suggests priorities for determining which types of barriers should be mitigated...
-
1016.5 Obstacles
Obstacles on outdoor recreation access routes, passing spaces, and resting intervals shall not exceed 1/2 inch (13 mm) in height measured vertically to the highest point....
-
703.3.1 Dimensions and Capitalization
Table 703.3.1 Braille Dimensions Measurement Range Minimum in Inches Maximum in Inches Dot base diameter 0.059 (1.5 mm) to 0.063 (1.6 mm)...
-
1016.5 Obstacles
Obstacles on outdoor recreation access routes, passing spaces, and resting intervals shall not exceed 1/2 inch (13 mm) in height measured vertically to the highest point....
-
11B-705.1.1.2 Dome spacing
detectable warning surface shall have a center-to-center spacing of 2.3 inches (58 mm) minimum and 2.4 inches (61 mm) maximum, and a base-to-base spacing of 0.65 inch (16.5 mm) minimum, measured...
-
11B-705.1.2.2.2.1 One entrance/exit point
Where the turning space has one entrance/exit point other than the sloped ramp segments, detectable warnings shall be 36 inches (914 mm) deep, as measured perpendicular to the curb, and...
-
11B-809.8.3 Door maneuvering clearance.
At the dwelling unit side of the primary entry doors, secondary exterior doors, and required exit doors maneuvering clearances shall be 44 inches (1118 mm) minimum in length measured...
-
R410.9 Character Spacing
Character spacing shall be measured between the two closest points of adjacent characters, excluding word spaces....
-
§ 36.304(d)(3) Reduced scoping for public accommodations
For measures taken to comply with the barrier removal requirements of this section, existing facilities shall comply with the applicable requirements for alterations in § 36.402 and §§ 36.404...
-
Can handrails overlap ramp landings?
Along runs and landings, the minimum clear width must be measured between the leading edge of handrails....
-
§ 38.31(b)
(b) Other stepwells and doorways, including doorways in which lifts or ramps are installed, shall have, at all times, at least 2 foot-candles of illumination measured on the step tread,...
-
703.5.8 Character Spacing
Character spacing shall be measured between the two closest points of adjacent characters, excluding word spaces....
