You must accept the following as evidence that the animal is indeed a service animal: the credible verbal assurances of a passenger with a disability using the animal, the...
Search Results "Assurances from Contractors"
Commonly Searched Documents
-
Verification of Service Animals
-
Meeting Purpose
Note that whenever possible people should NOT be separated from assistance devices (cane, wheelchair, etc.)...
-
Factors to Consider in Planning For & Administering an ADA Facilities Compliance Plan
Your initial compliance efforts and your long-term success in integrating ADA requirements into your work will all benefit from early consideration of the following: First, consider your...
-
III.
Bass, 404 U.S. 336, 349 (1971) ("the requirement of a clear statement assures that the legislature has in fact faced, and intended to bring into issue, the critical matters involved in the...
-
Features of the ETA Standard Barrier Survey/Barrier Management System [Title II]
When possible, the barriers are all located on a floor or site plan to make sure the contractor who does the work can efficiently locate the problem in the field....
-
Back Wall: ADA Standard Section 607.4.2.1
Section 607.4.2.1 covers the current ADA Standards for back wall grab bars in bathtubs without permanent seats.
-
11B-809.10.7.2 Location
The centerline of the water closet shall be 17 inches (432 mm) minimum to 18 inches (457 mm) maximum from a wall or partition that is 54 inches (1372 mm) minimum in length....
-
11B-607.4.2.1 Back wall
Each grab bar shall be 24 inches (610 mm) long minimum and shall be installed 24 inches (610 mm) maximum from the head end wall and 12 inches (305 mm) maximum from the control end wall....
- Adaptive Engineering Inc. Mobilift TX Wheelchair Lift for Rail Access
-
11B-705.2 Detectable directional texture
texture at transit boarding platforms shall comply with Figure 11B-705.2 and shall be 0.1 inch (2.5 mm) in height that tapers off to 0.04 inch (1.0 mm), with bars raised 0.2 inch (5.1 mm) from...
-
1009.1 Accessible means of egress required
Where more than one means of egress are required by Section 1006.2 or 1006.3 from any accessible space, each accessible portion of the space shall be served by accessible means of egress...
-
11B-605.5.3 Doors
Doors shall be located in the front partition or in the side wall or partition farthest from the urinal....
-
Height Above Finish Floor or Ground: ADA Standard Section 703.4.1
Tactile characters on signs shall be located 48 inches (1220 mm) minimum above the finish floor or ground surface, measured from the baseline of the lowest tactile character and 60 inches...
-
Visible Signals: ADA Standard Section 407.2.2.2
Section 407.2.2.2 covers the current ADA Standards for elevator visible signals.
-
Location: ADA Standard Section 604.9.1
Section 604.9.1 covers the current ADA Standards for the mounting location of children's use water closets.
-
11B-604.9.1 Location
The centerline of the water closet shall be 12 inches (305 mm) minimum and 18 inches (457 mm) maximum from the side wall or partition, except that the water closet shall be 17 inches (432...
-
CIRCULATION PATH
Whenever the accessible route diverges from the regular circulation path signage may be required to identify the departure from the regular route if not obvious. ◼...
- QuickCaption Remote Realtime Captioning CART
-
Cord Length: ADA Standard Section 704.2.4
The cord from the telephone to the handset shall be 29 inches (735 mm) long minimum....
-
RUNNING SLOPE
(As differentiated from the definition of “Cross Slope”.)...
-
11B-704.2.4 Cord length
The cord from the telephone to the handset shall be 29 inches (737 mm) long minimum....
-
11B-203.1 General
Sites, buildings, facilities, and elements are exempt from these requirements to the extent specified by 11B-203....
-
1009.7.2 Separation
Exterior walls separating the exterior area of assisted rescue from the interior of the building shall have a minimum fire-resistance rating of 1 hour, rated for exposure to fire from the...
-
Position: ADA Standard Section 703.3.2
Braille shall be separated 3/8 inch (9.5 mm) minimum from any other tactile characters and 3/8 inch (9.5 mm) minimum from raised borders and decorative elements....