Elements located on circulation paths, including operable elements, must comply with requirements for protruding objects....
Search Results "Comply With"
Commonly Searched Documents
-
307.2 Protrusion Limits
-
11B-703.4.1 Height above finish floor or ground
Exception: Tactile characters for elevator car controls shall not be required to comply with Section 11B-703.4.1....
-
Alterations
This does not, however, change the requirement that if the intent was to alter the entire room or space, the entire room or space must be made accessible and comply with the applicable requirements...
-
What about service animals in training?
., search and rescue dogs) provided that they comply with other applicable requirements (e.g., the Animal Welfare Act)....
-
New Provisions for Employee Work Areas
This revision provides for greater maneuvering access within work areas but does not require elements or equipment that are part of a work station to comply with any other requirements....
-
M301.3.2 Leg Supports (Section-by-Section Analysis)
the final rule, this provision instructs that when stirrups are provided on diagnostic equipment used in the supine, prone, or side-lying position leg supports must also be provided and comply...
-
M302.3.2 Leg Supports (Section-by-Section Analysis)
The Access Board concurs with the commenters, and the final rule requires that where stirrups are provided on seated diagnostic equipment, leg supports must also be provided and must comply...
-
1002.4.3 Gaps
EXCEPTION: Where compliance is not operationally or structurally feasible, ramps, bridge plates, or similar devices complying with the applicable requirements of 36 CFR 1192.83(c) shall...
-
610.3 Shower Compartment Seats
Seats shall comply with 610.3.1 or 610.3.2. Figure 610.3 Extent of Seat...
-
703.3.1 Dimensions and Capitalization
Braille dots shall have a domed or rounded shape and shall comply with Table 703.3.1....
-
1115B.4.5, Item 5
Bathtubs required to be accessible shall comply with this subsection. 1. … 2. … 3. … 4. … 5. Shower unit. ...
-
1008.2.3 Water Play Components
Transfer systems complying with 1008.3 shall be permitted to connect elevated play components in water. Advisory 1008.2.3 Water Play Components....
-
Accessible Routes
The accessible route must comply with ADAAG provisions for the location, width (minimum of 36 inches), passing space, head room, surface, slope (maximum of 1:12 or 8.33%), changes in level...
-
404.2.4.2 Doorways without Doors or Gates, Sliding Doors, and Folding Doors
Doorways less than 36 inches (915 mm) wide without doors or gates, sliding doors, or folding doors shall have maneuvering clearances complying with Table 404.2.4.2....
-
232.2 General Holding Cells and General Housing Cells
EXCEPTION: Alterations to cells shall not be required to comply except to the extent determined by the Department in accordance with the variance procedures contained in Chapter 68, Texas...
-
Identification of accessible guest rooms. (Section-by-Section Analysis)
As a practical matter, a public accommodation's designation of a guest room as "accessible" will not necessarily ensure that the room complies with all of the 1991 Standards. ...
-
Certification.
The current title III regulation provides that state or local governments may apply to the Department for certification that state laws or local building codes comply with or exceed the...
-
ABA Enforcement
between the complainant and the federal agency because we protect the identity of the complainant, and that is because, under the ABA, this is a fact-based investigation: Does the building comply...
-
Appendix B: An Example from State Legislation and Policy: Maryland
www.marylandpublicschools.org/NR/rdonlyres/84C4C717-B8FF-486B-8659- 79F297DF5B38/19715/Servingstudents2.pdf The Maryland State Department of Education published this guide for schools to comply...
-
1002.5 Amusement Ride Seats Designed for Transfer
Amusement ride seats designed for transfer shall comply with 1002.5 when positioned for loading and unloading. Advisory 1002.5 Amusement Ride Seats Designed for Transfer....
-
604.7 Dispensers
Toilet paper dispensers shall comply with 309.4 and shall be 7 inches (180 mm) minimum and 9 inches (230 mm) maximum in front of the water closet measured to the centerline of the dispenser...
-
1008.2.3 Water Play Components
Transfer systems complying with 1008.3 shall be permitted to connect elevated play components in water. Advisory 1008.2.3 Water Play Components....
-
C.7.i. - Must Portable Document Format (PDF) files that are displayed on a Federal website meet the Access Board's standards?
Section 1194.22(m) requires the web page containing a PDF file to include a link to a plug-in that complies with the software requirements of 1194.21(a) through (l)....
-
§8.56(a) Periodic compliance reviews
The responsible civil rights official or designee may periodically review the practices of recipients to determine whether they are complying with this part and where he or she has a reasonable...