Swinging door or gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
Search Results "Access Aisle Width"
-
1132A.9 Smooth surface
-
Shape and Diameter
A gripping surface width between 1¼ to 1½ inches diameter is specified....
-
4.34.6.7* OVENS
For side-opening ovens, the door latch side shall be next to the open counter space, and there shall be a pull-out shelf under the oven extending the full width of the oven and pulling out...
-
1.1.12 Ramp cross slope
slope of ramps by establishing elevations at the extreme edges of the ramp at the top and bottom of the ramp and calculate the cross slope at these two locations using the horizontal ramp width...
-
11B-1002.4.4.2 Side entry
A 32 inch (815 mm) clear opening will not provide sufficient width when entered through a turn into an amusement ride....
-
11B-1002.4.4.2 Side entry
A 32 inch (815 mm) clear opening will not provide sufficient width when entered through a turn into an amusement ride....
-
11B-704.2.1.2 Forward approach
If an additional 6 inches (152 mm) in width of clear floor space is provided, creating a clear floor space of 36 inches by 48 inches (914 mm by 1219 mm), the enclosure may extend more than...
-
Marx|Okubo Accessibility Specialist - California, Seattle, or Denver
Apply for the Accessibility Specialist here....
-
Addressing Accessibility in Capital Needs: Part 1 - HUD - 5/18/12
-
806 Transient Lodging Guest Rooms
Commenters noted that in guest rooms with two beds, each bed was positioned close to a wall, reducing access on one side....
-
G.7.i. - Are procurement actions to maintain existing legacy systems (that do not meet the technical provisions of the Access Board's standards) exempt from Section 508?
agency is acquiring "patches" to fix minor software errors on a system that is not near the end of its life expectancy and software that meets the applicable technical provisions of the Access...
-
SETTLEMENT AGREEMENT BETWEEN THE UNITED STATES OF AMERICA AND FAUQUIER COUNTY REGARDING THE ACCESSIBILITY OF POLLING PLACES
DJ # 204-79-321 This Settlement Agreement (the "Agreement") is entered into between the United States of America and Fauquier County (collectively, the "Parties").
-
Trailhead Information Signs [F216.13 and 1017.10]
new trail information signs must include the following information: Length of the trail or trail segment Type of trail surface Typical and minimum trail tread width...
-
If a state or local authority interprets an accessibility requirement differently than how a comparable requirement in the ADA Standards is interpreted under the ADA (or waives that requirement completely), does this have any bearing on ADA compliance?
While state or local authorities may interpret or waive their own state or local accessibility codes as they see fit, those decisions have no effect on the obligation to comply with requirements...
-
Alterations and water closet clearances in single-user toilet rooms with in-swinging doors. (Section-by-Section Analysis)
A number of commenters stated that there was no reason to return this provision to the Access Board....
-
Figure 408.4.1(c) Limited-Use/Limited-Application (LULA) Elevator Car Dimensions – Drawing from the U.S. Access Board
-
Figure 408.4.1(b) Limited-Use/Limited-Application (LULA) Elevator Car Dimensions – Drawing from the U.S. Access Board
-
Future Work
Future studies should look into the effects of variable ‘side guard’ widths, heights, contours and shapes to see if it such as structure could act more as a benefit versus a hindrance to...
-
(1) Transfer Surface Location for Diagnostic Equipment Used in the Supine, Prone, or Side-lying Position
The MDE Advisory Committee recommended permitting an alternative transfer surface which was rotated in its orientation such that the width paralleled the examination surface’s length and...
-
GE® 27" Drop-In Electric Range JM250DFBB
Content Weights and Dimensions Cooktop Width 27 1/8 in Approximate Shipping Weight 124 lb Cabinet Opening 27 in...
-
Inpro Corporation JointMaster® 806 Series Floor Expansion Joint Covers
existing conditions, additions and new construction Anti-slip surface serrations Key Specifications Floor to floor Movement: +/- 25% to +/- 50% Joint width...
-
Mockett CH13K Quadruple Organic Coat Hooks
Size: 4 3/8" high, 20 1/2" overall width, 2 3/16" projection. Mounting hardware included. Finishes: Matte Black, Satin Nickel, Polished Chrome and Metallic Silver....
-
11B-221.2.3.1 Horizontal dispersion
Intermediate aisles shall be included in determining the total row length....
-
226.1 General
Check writing surfaces provided at check-out aisles not required to comply with 904.3 shall not be required to comply with 902. Advisory 226.1 General....
