The ADA accessibility standard for alterations requires wheelchair seating to be dispersed (i.e. , provided in more than one location) only in assembly areas with fixed seating for more...
Search Results "ADA Compliance"
Filters
Commonly Searched Documents
-
III-4.4600 Seating in assembly areas
-
IV. DEFINITIONS
"Disability" will be defined as it is in the ADA, 42 U.S.C. § 12102(1). See also 28 C.F.R. § 35.108....
-
Telephones
According to the ADA regulations, meeting facilities that provide equipment for participants to make outgoing calls on “more than an incidental convenience basis” must provide the same opportunity...
-
7.1. Purpose and Objective of the Final Rule, Relative to Movie Theaters Categorized As Small
As noted earlier in this Final RA (see Section 1.1), the Department’s existing regulation implementing the ADA’s title III auxiliary aids provision reiterates the obligation of covered...
-
Section 36.206 Retaliation or Coercion (Section-By-Section Analysis and Response to Comments)
Section 36.206 Retaliation or Coercion (Section-By-Section Analysis and Response to Comments) Section 36.206 implements section 503 of the ADA, which prohibits retaliation against any...
-
Commercial Facilities (Section-By-Section Analysis and Response to Comments)
The interplay between the Fair Housing Act and the ADA with respect to those facilities that are "places of public accommodation'' was the subject of many comments and is addressed in the...
-
Transfer Sides (M301.2.3 and M302.2.3)
The 2004 ADA and ABA Accessibility Guidelines provide a gap of 3 inches between the edge of a shower seat and the shower compartment entry, and the gap does not appear to interfere with...
-
Medical Device Manufacturers
If DOJ amends its ADA regulations as announced in the ANPRM, medical device manufacturers may have an economic incentive to produce accessible products that conform to the standards for...
-
Definitions of residential facilities and transient lodging. (Section-by-Section Analysis)
The ADA does not exempt spaces because of a belief or policy that excludes persons with disabilities from certain work....
-
Appendix E to Part 37—Reasonable Modification Requests
The Department's ADA regulations contain numerous requirements concerning fixed route, complementary paratransit, and other types of transportation service....
-
11B-404.2.7 Door and gate hardware
. ◼ [2010 ADA Standards] 404.2.7 Door and Gate Hardware. Handles, pulls, latches, locks, and other operable parts on doors and gates shall comply with 309.4....
-
Clear Width of Circulation Paths and Maneuvering Clearances at Wheelchair Spaces
Providers of paratransit services also urged the Board to exempt cutaway vehicles (minibuses) used for paratransit because their small size would make compliance difficult, result in loss...
-
Toilet Buildings and Pit Toilets
When there are walls, ensure doorways or wall openings that provide entrance to the toilet have a minimum clear width of 32 inches (815 millimeters), in compliance with ABAAS, section 404.2.3...
-
Ticket Prices and Dispersal of Wheelchair Spaces
Paragraph 5 of the "Line of Sight and Dispersion of Wheelchair Spaces in Assembly Areas" section of the Department of Justice's Guidance on the 2010 ADA Standards for Accessible Design document...
-
M301.4.1 Clearance in Base (Section-by-Section Analysis)
The final commenter explained that a standard that only required either compliance with clearance in the base or clearance around the base, was attainable, but warned that if both were required...
-
Summary of the project
and maintenance of exterior surfaces are also issues; g) training, availability, and skill levels of construction workers must be considered; h) contractors and others responsible for compliance...
-
California: Toilet Grab Bars - Uneven height allowed?
I noticed that the specific code language suggests that the side grab bar and the rear grab bar must be at the same height (California CBC text is slightly different than ADAS), but it reads...
-
Preserving elevator access in building where it might not be required.
Here's the scenario: Pre-ADA building. Each story less than 3000 square feet, so elevator would likely not be required if built new. 2010 Standards 206.2.3, Exception 1. ...
-
b) Accessibility
the maximum localized variation as the overall slope of the curb ramp rather than the curb ramp's overall "rise in run" and flatness, which is the appropriate measure of accessibility compliance...
-
What Kind Of Documentation Is Sufficient To Support A Request For Testing Accommodations?
professional does not include every test or subtest score preferred by the testing entity in the psychoeducational or neuropsychological report. 3 Under Section 309 of the ADA...
-
Panda S.10 All Aluminum Lift & Slide System
Trench Depth: Min. 1 1/4″ ADA Compliant 1 1/4″ in track. ...
-
Airforce Hi-Speed Energy Efficient Hand Dryer
Amps, 1100 Watts, 60 Hz 208-240 V – 4.8 Amps, 1100 Watts, 60 Hz 220-240 V – 4.8 Amps, 1100 Watts, 50 Hz Certification: cULus, CE, TUV-GS, IP24, GreenSpec ADA...
-
Stanley QCL 100 Series Grade 1 Heavy Duty Cylindrical Locks
Certifications ANSI/BHMA A156.2 Series Grade 1 ANSI A117.1 Accessibility Code (ADA Compliant) UL/cUL listed(3-hours) for “A” label single door applications (4' x 8...
