Current standards have criteria only related to seat height and clear floor space for wheelchair users (2)....
Search Results "Adjustable Height Counter"
-
Chapter 1: Background
-
9.2.2(7) Kitchens, Kitchenettes, or Wet Bars
Clear floor space for a front or parallel approach to cabinets, counters, sinks, and appliances shall be provided to comply with 4.2.4....
-
Clear Space Evaluation
However, when looking at Protocol A for the maximum height transfer only 65% of the population could transfer entirely inside of the 60 x 55.5 inch defined space....
-
Adjustable height/gap protocol
Adjustable height/gap protocol: From the initial setup, a gap separating the device and platform was introduced with the plywood blocks of 3.5” (8.9cm) and then the height of platform was...
-
M301.2.3.1 End Transfer Surface
End transfer surfaces shall be 28 inches (710 mm) wide minimum and 17 inches (430 mm) long minimum. EXCEPTION: Transfer surfaces for imaging equipment with bores shall be...
-
M301.2.3.2 Side Transfer Surface
Side transfer surfaces shall be 28 inches (710 mm) wide minimum and 28 inches (710 mm) long minimum. EXCEPTION: Transfer surfaces for imaging equipment with bores shall be...
-
M301.2.4 Unobstructed Transfer
Each transfer surface shall provide two unobstructed sides for patient transfer. EXCEPTIONS: 1. Obstructions no more than 3 inches (75 mm) deep shall be permitted to extend beyond...
-
M301.4 Lift Compatibility
Diagnostic equipment shall be usable with portable patient lifts and, when in use with such lifts, shall comply with M301.4.1 or M301.4.2. EXCEPTION: Where fixed overhead patient...
-
M301.2.4 Unobstructed Transfer (Section-by-Section Analysis)
In the MDE NPRM the Access Board proposed that each transfer side provide unobstructed access to the transfer surface, with an exception to permit temporary obstructions as long as...
-
M301.4 Lift Compatibility
Diagnostic equipment shall be usable with a patient lift and shall comply with M301.4.1 or M301.4.2.
-
M301.2.3 Transfer Sides
The transfer surface shall be located to provide options to transfer from a mobility device onto one short side (depth) and one long side (width) of the surface. Each transfer side...
-
4.9.2 Treads and Risers
On any given flight of stairs, all steps shall have uniform riser heights and uniform tread widths....
-
5.4.1 Transfer Support Location for M301 and M302
Rationale for the recommendation Transfer supports or handholds on adjustable medical equipment facilitate transfers onto a transfer surface by giving the individual something to hold...
-
Study Objectives
Floor space needed for level, highest and lowest height transfers to seats without handhelds, with grab-bars, and with grab bars and a backrest d....
- Murdock Manufacturing Waterless Campground Urinal, Front Mount
-
3.2 Getting on the Table
An accessible table is height adjustable to a minimum height of 17- 20 inches from the floor. ...
-
703.4 Installation Height and Location
703.4 Installation Height and Location. Signs with tactile characters shall comply with 703.4....
-
Key Study findings:
The majority of participants (e.g. the 5th percentile or approximately 95% of the study sample) could transfer independently to a platform at a height that was within one inch of the...
- IDeA Center: Transferring from Wheeled Mobility to MidMark's Barrier-Free Examining Table
-
703.4.1 Height above Finish Floor or Ground
703.4.1 Height above Finish Floor or Ground....
-
1011.8 Viewing Scopes
Eyepieces on viewing scopes shall be 43 inches (1090 mm) minimum and 51 inches (1295 mm) maximum above the ground.