If a Lease Evaluation Form is not submitted, compliance with all applicable standards shall be required....
Search Results "ANSI/IEEE: American National Standards Institute/ Institute of Electrical and Electronics Engineers"
Commonly Searched Documents
-
68.101(b) Lease Evaluation Form
-
Regulatory Flexibility Act: Initial Regulatory Flexibility Analysis
The proposed standards do not impose any mandatory requirements on any entity, including small entities....
-
8. Boarding Separately From Wheelchair
(Note, however, that under § 37.165(b), entities are required to accommodate device/user loads and dimensions that exceed the former “common wheelchair” standard, as long as the vehicle...
-
11B-1008.2.6 Ground surfaces
Ground surfaces must be inspected and maintained regularly to ensure continued compliance with the ASTM F 1951 standard....
-
8. Boarding Separately From Wheelchair
(Note, however, that under §37.165(b), entities are required to accommodate device/user loads and dimensions that exceed the former “common wheelchair” standard, as long as the vehicle and...
-
1.1.4 Appendices
code shall not apply unless specifically adopted by a state agency or adopted by a local enforcing agency in compliance with Health and Safety Code Section 18901 et. seq. for Building Standards...
-
11B-809.4.1 Subsequent bathrooms
ETA Editor's Note The requirement for an accessible shower at subsequent bathrooms prescribed by CBC 11B-809.4.1 is not required by 2010 ADA Standards....
-
11B-703.2.5 Character height
[2010 ADA Standards] EXCEPTION: Where separate raised and visual characters with the same information are provided, raised character height shall be permitted to be ½ inch (13 mm)...
-
1.1.4 Appendices
code shall not apply unless specifically adopted by a state agency or adopted by a local enforcing agency in compliance with Health and Safety Code Section 18901 et. seq. for Building Standards...
-
11B-703.2.4 Character proportions
[2010 ADA Standards] 703.2.4 Character Proportions....
-
11B-703.5.4 Character proportions
[2010 ADA Standards] 703.5.4 Character Proportions....
-
11B-1008.2.6 Ground surfaces
Ground surfaces must be inspected and maintained regularly to ensure continued compliance with the ASTM F 1951 standard....
-
11B-604.2 Location
[2010 ADA Standards] 604.2 Location. The water closet shall be positioned with a wall or partition to the rear and to one side....
-
11B-213.3.6 Bathing facilities
[2010 ADA Standards] 213.3.6 Bathing Facilities....
-
11B-604.6 Flush controls
[2010 ADA Standards] 604.6 Flush Controls. Flush controls shall be hand operated or automatic. Hand operated flush controls shall comply with 309....
-
11B-1009.2.7 Operation
[2010 ADA Standards] 1009.2.7 Operation. The lift shall be capable of unassisted operation from both the deck and water levels....
- Speed Queen® Front Load Washer Information Video
-
A. Movie Basics, Captioning, and Audio Description Generally
Testimony of John Fithian, President and CEO of the National Association of Theater Owners, Before the U.S....
- Cryptzone
-
Test C (Section-by-Section Analysis)
The Americans with Disabilities Act uses the same "regarded as" test set forth in the regulations implementing section 504 of the Rehabilitation Act....
-
Acceleration
American Association of State Highway and Transportation Officials. Guide for the Development of Bicycle Facilities....
-
Section 1630.1(c) Construction
In addition, unless expressly stated otherwise, the standards applied in the ADA are intended to provide at least as much protection as the standards applied under the Rehabilitation Act...
-
Safe harbor and other proposed limitations on barrier removal.
One of the most important issues that the Department must address is the effect that supplemental or changed ADA Standards will have on the continuing obligation of public accommodations...
-
4. Exception from the Requirements of M301 for Certain Examination Chairs that Comply with M302
The Access Board proposed in M101.2 in the MDE NPRM to require diagnostic equipment to meet the standards for each patient position supported, meaning that if diagnostic equipment was designed...