(j) Products that transmit or conduct information or communication, shall pass through cross-manufacturer, non-proprietary, industry-standard codes, translation protocols, formats or other...
Search Results "ANSI/IEEE: American National Standards Institute/ Institute of Electrical and Electronics Engineers"
Filters
Commonly Searched Documents
-
§ 1194.23(j)
-
Accessible Route
- Source: Definition from The ADA Standards at § 3.5....
-
5. WAIVERS
Any other deviation from these DoD Standards shall be made only through the waiver or modification process....
-
16. Modification to be completed within six months
other modifications necessary to bring the Hotel, and its goods, services, facilities, privileges, advantages, and accommodations into compliance with the ADA Title III regulation and 2010 Standards...
-
f-v
[ADA Standards § 4.8.4] Yes No Note: if the running slope is less than 1:16 but more than 1:20, each ramp segment may be up to 40 feet long followed by a level landing]....
-
B4
[ADA Standards § 4.6.5] Yes No If No: Can the route be cleared by removing or raising low objects, or can each van accessible parking space be relocated?...
-
E101.4 Units of Measurement (Section-by-Section Analysis)
This proposed section is new to the 508 Standards and would clarify dimensions stated in the text of the proposed rule....
-
E202.3 Federal Contracts
ICT acquired by a contractor incidental to a contract shall not be required to conform to the 508 Standards. Advisory E202.3 Federal Contracts....
-
Question 1
The Department is considering adopting the Access Board's standards for medical diagnostic equipment....
-
Dispersion
Dispersion Recommendation: Wheelchair accessible units and standard units should be evenly dispersed to maximize convenient availability....
-
Drinking Fountains and Water Coolers [4.15]
Units that meet conventional industry standards are acceptable for providing access to people who have difficulty bending or stooping....
-
Salad Bars and Buffet Counters
Salad Bars and Buffet Counters Recommendations: The standard reach range should be considered in the design of built-in salad bars although not all portions are required to be within...
-
Surface Smoothness
The standards limit changes in level and openings in floor and ground surfaces, but they do not further address overall surface smoothness....
-
Must van accessible spaces be restricted to van use?
State or local codes and regulations may require additional verbiage, but the ADA Standards do not....
-
Disproportionality (20%)
Regulations implementing the standards define “disproportionate” as exceeding 20% of the total cost of alterations to the primary function area....
-
Are exit doors usable only in one direction required to comply on both sides?
Under the ADA Standards, compliance is not required on both sides of those doors or gates that can be used in one direction only, such as exit-only doors....
-
§ 35.150(b)(4) Swimming pools, wading pools, and spas
The requirements set forth in sections 242 and 1009 of the 2010 Standards shall not apply until January 31, 2013, if a public entity chooses to make structural changes to existing swimming...
-
68.101(b) Lease Evaluation Form
If a Lease Evaluation Form is not submitted, compliance with all applicable standards shall be required....
-
Regulatory Flexibility Act: Initial Regulatory Flexibility Analysis
The proposed standards do not impose any mandatory requirements on any entity, including small entities....
-
8. Boarding Separately From Wheelchair
(Note, however, that under § 37.165(b), entities are required to accommodate device/user loads and dimensions that exceed the former “common wheelchair” standard, as long as the vehicle...
-
11B-1008.2.6 Ground surfaces
Ground surfaces must be inspected and maintained regularly to ensure continued compliance with the ASTM F 1951 standard....
-
8. Boarding Separately From Wheelchair
(Note, however, that under §37.165(b), entities are required to accommodate device/user loads and dimensions that exceed the former “common wheelchair” standard, as long as the vehicle and...
-
1.1.4 Appendices
code shall not apply unless specifically adopted by a state agency or adopted by a local enforcing agency in compliance with Health and Safety Code Section 18901 et. seq. for Building Standards...
-
11B-1008.2.6 Ground surfaces
Ground surfaces must be inspected and maintained regularly to ensure continued compliance with the ASTM F 1951 standard....