In standard roll-in type shower compartments, the controls, faucets, and shower spray unit shall be located above the grab bar, but no higher than 48 inches (1220 mm) above the shower floor...
Search Results "Shall"
-
608.5.2 Standard Roll-In Type Shower Compartments
-
11B-233.3.1.2 Residential dwelling units with adaptable features
In facilities with residential dwelling units, adaptable residential dwelling units complying with Sections 11B-809.6 through 11B-809.12. shall be provided as required by Sections 11B-233.3.1.2.1...
-
11B-604.8.1.4 Toe clearance
Partition components at toe clearances shall be smooth without sharp edges or abrasive surfaces....
-
Reporting
Reporting Six (6) months after the effective date of this Agreement, and every six (6) months thereafter during the term of this Agreement, the City shall provide a written report...
-
11B-604.8.1.4 Toe clearance
Partition components at toe clearances shall be smooth without sharp edges or abrasive surfaces....
-
NFPA
Add Section 29.7.2.1 as follows: 29.7.2.1 The alarm verification feature shall not be used for household fire warning equipment....
-
11B-610.3.1 Rectangular seats
The rear edge of a rectangular seat shall be 2½ inches (64 mm) maximum and the front edge 15 inches (381 mm) minimum and 16 inches (406 mm) maximum from the seat wall....
-
NEW CONSTRUCTION AND ALTERATIONS {35.151}
NEW CONSTRUCTION AND ALTERATIONS {35.151} New Construction Shall be designed and constructed to be readily accessible to and usable by individuals with disabilities...
-
4.17.6 GRAB BARS
Grab bars complying with the length and positioning shown in Fig. 30(a), (b), (c), and (d) shall be provided....
-
406.2 Counter Slope
Counter slopes of adjoining gutters and road surfaces immediately adjacent to the curb ramp shall not be steeper than 1:20....
-
11B-224.7.1 Multi-bedroom housing units with mobility features
Multi-bedroom housing units containing accessible sleeping rooms with mobility features shall have an accessible route throughout the unit in compliance with Section 11B-809.2....
-
4.3.2(1)
(1) At least one accessible route within the boundary of the site shall be provided from public transportation stops, accessible parking, and accessible passenger loading zones, and public...
-
11B-1008.4.4 Entry points and seats
Where play components require transfer to entry points or seats, the entry points or seats shall be 11 inches (279 mm) minimum and 24 inches (610 mm) maximum from the clear floor or ground...
-
1009.8.2 Directions
Directions for the use of the two-way communication system, instructions for summoning assistance via the two-way communication system and written identification of the location shall be...
-
11B-1009.2.2 Seat location
In the raised position, the centerline of the seat shall be located over the deck and 16 inches (406 mm) minimum from the edge of the pool....
-
11B-225.2.2 Self-service shelving
Self-service shelves shall be located on an accessible route complying with Section 11B-402. Self-service shelving shall not be required to comply with Section 11B-308....
-
11B-809.10.3 Powder rooms
Powder rooms shall be designed to comply with Sections 11B-809.7, 11B-809.8, 11B-809.10.5.2, 11B-809.10.6.4, 11B-809.10.7.3, and 11B-809.12....
-
11B-406.2 Perpendicular curb ramps
Perpendicular curb ramps shall comply with Sections 11B-406.2 and 11B-406.5....
-
405.7.3 Length
The landing clear length shall be 60 inches (1525 mm) long minimum....
-
408.4.3 Platform to Hoistway Clearance
The platform to hoistway clearance shall comply with 407.4.3....
-
1017.3 Clear Tread Width
The clear tread width of trails shall be 36 inches (915 mm) minimum....
-
4.9.6 OUTDOOR CONDITIONS
Outdoor stairs and their approaches shall be designed so that water will not accumulate on walking surfaces....
-
T207.4 Circulation Paths
Handrails, stanchions, and handholds shall be provided along circulation paths in accordance with T207.4....
-
505.7 Cross Section
Handrail gripping surfaces shall have a cross section complying with 505.7.1 or 505.7.2....