A walking surface that has a running slope steeper than 1:20....
Search Results "Curb Ramp Surface"
Commonly Searched Documents
-
106.5.53 Ramp
-
DSA IR 11B-3: DETECTABLE WARNINGS AT CURB RAMPS (with revisions issued through Jan. 2011)
General: California Building Code Sections 1127B.5 Item 8 and 1117A.4.7 state “a curb ramp shall have a detectable warning….when the ramp slope is less than 1 unit vertical to 15 units horizontal...
-
General: ADA Standard Section 302.1
Section 302.1 of the ADA Standards covers information in the current ADA Standards for floor or ground surfaces.
-
Surface discontinuities
Differences in level between two adjacent surfaces. Elevation changes due to ramps or stairs do not, themselves, constitute surface discontinuities....
-
Surfaces for Outdoor Recreation Access Routes
Firm and stable surfaces prevent assistive devices from sinking into the surface....
-
What types of facilities are covered by DOT’s ADA Standards (and are required to have detectable warnings on curb ramps)?
Curb ramp detectable warnings are required only at these facilities....
-
T302.4 Surface Discontinuities
Surface discontinuities shall be ½ inch (13 mm) high maximum and shall be beveled with a slope not steeper than 1:2. EXCEPTIONS: 1....
-
1.2.1 Walks and other non - ramp surfaces
1.2.1 Walks and other non - ramp surfaces. When overall running slope for walks is measured according to Section 1.1.3 a recommended tolerance for running slope is +1%....
-
Suspicious Minds Ramp
Suspicious Minds Ramp: p. The ramp leading to the exhibits has a rise greater than 6", but does not have the required handrails on both sides. See Standards § 4.8.5. q....
-
1015.5 Surface
This section requires the surface of the clear ground space and turning space to be firm and stable....
-
Check Writing Surfaces: ADA Standard Section 904.3.3
Where provided, check writing surfaces shall comply with 902.3....
-
Can handrails overlap ramp landings?
This also applies to landings required to be at least 60” by 60” where ramps change directions so that the minimum landing area remains clear....
-
11B-1003.2.2 Boarding piers at boat launch ramps
Accessible routes serving boarding piers at boat launch ramps shall be permitted to use the exceptions in Section 11B-1003.2.2....
-
Ramps
Slightly steeper running slopes are permitted for short ramps (maximum 6” rise) where space is limited (§405.2, Ex.)....
-
Handrail Height: ADA Standard Section 1008.2.5.3.2
The top of handrail gripping surfaces shall be 20 inches (510 mm) minimum and 28 inches (710 mm) maximum above the ramp surface....
-
11B-1008.2.5.3.2 Handrail height
The top of handrail gripping surfaces shall be 20 inches (508 mm) minimum and 28 inches (711 mm) maximum above the ramp surface....
- SafeLane® Surface Overlay in Action
-
3.2.3 Surface
The ground surface in all camp living areas shall be firm and stable. The type of surface should be appropriate to the setting and level of development....
-
Performance for Surface Firmness and Stability
Performance for Surface Firmness and Stability Table 1 identifies the 11 test surface materials, the dates of installation, and the date of the initial and final testing of surfaces at...
-
11B-306.3.4 Clearance reduction
Exception: The knee clearance shall not be reduced at built-in dining and work surfaces required to be accessible by Section 11B-226.1....
-
405 Ramps
[See subsections ...]
-
405 Ramps
[See subsections ...]
-
A4.8 Ramps
[See subsections ...]
-
4.8 Ramps
[See subsections ...]