Exceptions: In load or unload areas and on amusement rides, where compliance with Section 11B-405.2 is not structurally or operationally feasible, ramp slope shall be permitted...
Search Results "Curb Ramp Surface"
-
11B-1002.2 Accessible routes
-
Surfaces for Outdoor Recreation Access Routes
Firm and stable surfaces prevent assistive devices from sinking into the surface....
-
Surface discontinuities
Differences in level between two adjacent surfaces. Elevation changes due to ramps or stairs do not, themselves, constitute surface discontinuities....
-
1013.2 Where required
Guards shall be located along open-sided walking surfaces, including mezzanines, equipment platforms, stairs, ramps and landings that are located more than 30 inches (762 mm) measured vertically...
-
1015.2 Where required
Guards shall be located along open-sided walking surfaces, including mezzanines, equipment platforms, aisles, stairs, ramps and landings that are located more than 30 inches (762 mm) measured...
-
106.5.53 Ramp
A walking surface that has a running slope steeper than 1:20....
-
T302.4 Surface Discontinuities
Surface discontinuities shall be ½ inch (13 mm) high maximum and shall be beveled with a slope not steeper than 1:2. EXCEPTIONS: 1....
-
Guldmann Excellent Ramp System
With this new ramp system, you can easily assemble a ramp to fit any type of door opening or threshold and still be able to close the door without taking the ramp away. ...
-
1015.5 Surface
This section requires the surface of the clear ground space and turning space to be firm and stable....
-
Q8: Curb Ramp Replaced as Part of a Resurfacing Alteration and Adjacent Sidewalk
Q8: If an existing curb ramp is replaced as part of a resurfacing alteration, is there an obligation to address existing obstacles on the adjacent sidewalk at the same time? A8: No....
-
EXHIBIT A Required Accessible Elements at QuikTrip Stores
Surfaces. In accordance with the ADA Standards, ramps and approaches shall be designed so that water will not accumulate on walking surfaces. 3. Curb Ramps....
-
1.2.1 Walks and other non - ramp surfaces
1.2.1 Walks and other non - ramp surfaces. When overall running slope for walks is measured according to Section 1.1.3 a recommended tolerance for running slope is +1%....
-
Check Writing Surfaces: ADA Standard Section 904.3.3
Where provided, check writing surfaces shall comply with 902.3....
-
DSA IR 11B-3: DETECTABLE WARNINGS AT CURB RAMPS (with revisions issued through Jan. 2011)
General: California Building Code Sections 1127B.5 Item 8 and 1117A.4.7 state “a curb ramp shall have a detectable warning….when the ramp slope is less than 1 unit vertical to 15 units horizontal...
-
Suspicious Minds Ramp
Suspicious Minds Ramp: p. The ramp leading to the exhibits has a rise greater than 6", but does not have the required handrails on both sides. See Standards § 4.8.5. q....
-
What types of facilities are covered by DOT’s ADA Standards (and are required to have detectable warnings on curb ramps)?
Curb ramp detectable warnings are required only at these facilities....
-
SafeLane® Surface Overlay in Action
Protecting people, roads and infrastructure, SafeLane® surface overlay from Cargill Deicing Technology is the only pavement overlay with anti-icing capabilities....
-
Can handrails overlap ramp landings?
This also applies to landings required to be at least 60” by 60” where ramps change directions so that the minimum landing area remains clear....
-
3.2.3 Surface
The ground surface in all camp living areas shall be firm and stable. The type of surface should be appropriate to the setting and level of development....
-
11B-1003.2.2 Boarding piers at boat launch ramps
Accessible routes serving boarding piers at boat launch ramps shall be permitted to use the exceptions in Section 11B-1003.2.2....
-
11B-1003.2.2 Boarding piers at boat launch ramps
Accessible routes serving boarding piers at boat launch ramps shall be permitted to use the exceptions in Section 11B-1003.2.2....
-
Ramps
Slightly steeper running slopes are permitted for short ramps (maximum 6” rise) where space is limited (§405.2, Ex.)....
-
Performance for Surface Firmness and Stability
Performance for Surface Firmness and Stability Table 1 identifies the 11 test surface materials, the dates of installation, and the date of the initial and final testing of surfaces at...
-
11B-306.3.4 Clearance reduction
Exception: The knee clearance shall not be reduced at built-in dining and work surfaces required to be accessible by Section 11B-226.1....
