Web Content Accessibility Guidelines (WCAG) 2.0, W3C Recommendation, December 11, 2008, would be incorporated by reference in sections E205.1, E207.2, 405.1 Exception, 501.1 Exception 1,...
Search Results "9-1-1 Service"
-
E102.9 W3C (Section-by-Section Analysis)
-
E202.5 Undue Burden or Fundamental Alteration (Section-by-Section Analysis)
Undue Burden or Fundamental Alteration (Section-by-Section Analysis) This section proposes to retain the provisions in existing 508 Standards §§ 1194.3(e) and 1194.2(a)(1), but would...
-
F216.1 General
EXCEPTIONS: 1....
-
Door and Signal Timing
This provision helps ensure that elevator doors remain open long enough for persons with disabilities to travel from call buttons to the responding car and is based on a travel speed of 1...
-
Questions and Answers: Enforcement Guidance on Disability-Related Inquiries and Medical Examinations of Employees Under the ADA
With Disabilities Act Amendments Act Of 2008 The Americans with Disabilities Act (ADA) Amendments Act of 2008 was signed into law on September 25, 2008 and becomes effective January 1,...
-
Reasonable Modification /Accommodation
Deccember [sic] 1, 2015...
-
303.3 Beveled
Changes in level between ¼ inch (6.4 mm) high minimum and ½ inch (13 mm) high maximum shall be beveled with a slope not steeper than 1:2. Advisory 303.3 Beveled....
-
C. Executive Order 13132 (Federalism)
This final rule does not include any provision that: (1) has substantial direct effects on the States, the relationship between the national government and the States, or the distribution...
-
Pushbutton-integrated APS
Pushbutton-integrated APS Figures 1 and 2 show several of the pushbutton-integrated APS devices that are available in the US....
-
B. Chapter 2: Scoping (Section-by-Section Analysis)
These concerns, discussed above in Section IV.A.1. (Significant Changes – General Exception), resulted in the addition of the M201.2 General Exception, described below....
-
Accessible Routes
The accessible route must comply with ADAAG provisions for the location, width (minimum of 36 inches), passing space, head room, surface, slope (maximum of 1:12 or 8.33%), changes in level...
-
Accessible Routes
Accessible route requirements in ADAAG address width (minimum of 36 inches), passing space, head room, surface, slope (maximum of 1:12 or 8.33%), changes in level, doors, egress, and areas...
-
409.1 General
residential dwelling unit required to provide mobility features complying with 809.2 shall comply with 409 and with ASME A17.1 (incorporated by reference, see “Referenced Standards” in Chapter 1)...
-
1008.2.1 Ground Level and Elevated Play Components
EXCEPTIONS: 1....
-
Cross Slope
Slope The cross slopes of gangways, transition plates and floating piers that are part of an accessible route must be designed and constructed to not exceed a maximum of 2 percent (1:...
-
Cashier counters
. § 36.303, Standards § 7.2(1)....
-
Comments from Individuals Who Are Blind or Have Low Vision (Section-by-Section Analysis)
on the 2002 draft guidelines from individuals who identified themselves as blind or having low vision supported requiring detectable warning surfaces on all curb ramps by a margin of 2:1....
-
B. Apprentice Training Programs
recipient enters into a written agreement with a labor union or other sponsor providing for apprentice training, the agreement must contain an assurance from the union or other sponsor: (1)...
-
(c) Thresholds at patio, deck or balcony doors
The final Guidelines provide that exterior deck, patio, or balcony surfaces should be no more than 1/2 inch below the floor level of the interior of the dwelling unit, unless they are constructed...
-
§ 36.105(e)(2) Broad construction
In determining whether an impairment substantially limited a major life activity, the principles articulated in paragraph (d)(1) of this section apply....
-
12142(b) Purchase and lease of used vehicles
(b) Purchase and lease of used vehicles Subject to subsection (c)(1) of this section, it shall be considered discrimination for purposes of section 12132 of this title and section 794...
-
Character Proportion [4.30.2]
Recommendation: While ADAAG does not specify the character to use in calculating proportions, SEGD recommends the capital "O" and number "0" for character proportion and the capital "I" and number “1"...
-
4.10.13* Car Position Indicators
Numerals shall be a minimum of 1/2 in (13 mm) high. The audible signal shall be no less than 20 decibels with a frequency no higher than 1500 Hz....