Exterior walls separating the exterior area of assisted rescue from the interior of the building shall have a minimum fire-resistance rating of 1 hour, rated for exposure to fire from the...
Search Results "Rate of Change"
Commonly Searched Documents
-
1009.7.2 Separation
-
1009.7.2 Separation
Exterior walls separating the exterior area of assisted rescue from the interior of the building shall have a minimum fire-resistance rating of 1 hour, rated for exposure to fire from the...
-
1007.7.4 Separation
Exterior walls separating the exterior area of assisted rescue from the interior of the building shall have a minimum fire-resistance rating of 1 hour, rated for exposure to fire from the...
-
711.4.1.2 Through-penetration firestop system
The system shall have an F rating and a T rating of not less than 1 hour but not less than the required rating of the floor penetrated....
-
Minimum Green Times
The AASHTO equation assumes a constant acceleration rate; however, this research shows that the assumption is not accurate....
-
Slope
The commenter stated that this is adequate when there is a uniform and reasonably consistent change in elevation between points (i.e., one point is at the top of a hill and the other is...
-
Questionnaire
The first question, shown in Figure 4, was based on ASTM 1927-28: Standard Guide for Conducting Subjective Pavement Ride Quality Ratings....
-
36 CFR Parts 1190 and 1191 ADA and ABA Accessibility Guidelines - Preamble (Discussion of Comments and Changes)
Americans with Disabilities Act (ADA) Accessibility Guidelines for Buildings and Facilities; Architectural Barriers Act (ABA) Accessibility Guidelines Preamble (Discussion of Comments and Changes...
- AbleRoad: An app and website that connects people with accessible places
-
F228 Depositories, Vending Machines, Change Machines, and Mail Boxes
The Board has clarified coverage of fuel dispensers in the final rule by adding a reference to them in the both the ADA scoping document (section 228) and the ABA scoping document...
- M-D Building Products, Inc. GEN2 SmartTool™ Digital Level
-
11B-407.4.8.2.1 Signal type
Exception: For elevators that have a rated speed of 200 feet per minute (1 m/s) or less, a non-verbal audible signal with a frequency of 1500 Hz maximum which sounds as the car passes or...
-
11B-306.3.4 Clearance reduction
Between 9 inches (229 mm) and 27 inches (686 mm) above the finish floor or ground, the knee clearance shall be permitted to reduce at a rate of 1 inch (25 mm) in depth for each 6 inches...
-
8.3 Results and Discussion
Median listener ratings for the Peak Clipping condition Clipping Levels re: Peak Because all of the groups rated the quality of the sentences similarly, recommendations stemming...
-
ICC/IBC: ADA Standard Section 105.2.4
Section 105.2.4 of the ADA Standards cover references to the International Code Council (ICC) and the International Building Code (IBC).
-
Exit Doors: ADA Standard Section 216.4.1
Section 216.4.1 covers scoping requirements in the current ADA Standards for signs at exit doors.
-
225(d)(1)(D)
(D) require that users of telecommunications relay services pay rates no greater than the rates paid for functionally equivalent voice communication services with respect to such factors...
-
General: ADA Standard Section 223.1
Section 223.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for medical care and long-term care facilities.
- BEA Inc. MS09 Hands Free Activation Door Access (Wave to Open)
-
Energy Consumption During Ambulation
Subjects walked on each surface at their preferred pace, until the physiological variables (energy consumption, heart rate, velocity) had stabilized (2‒3 minutes) and the data collection...
-
Attachment A: Violations Identified in the United States' Letter of Findings (Sept. 29, 2014)
[See subsections ...]
-
711.4.1 Through penetrations
Through penetrations of fire-resistance-rated horizontal assemblies shall comply with Section 711.4.1.1 or 711.4.1.2....
-
711.3.1.2 Through-penetration firestop system
approved penetration firestop system installed as tested in accordance with ASTM E 814, with a minimum positive pressure differential of 0.01 inch (2.49 Pa) of water and shall have an F rating...