INTERPRETATION For the purposes of this CAN, the specific area of alteration is equivalent to the altered element or space described in Section 11B-202.3 in this CAN....
Search Results "Shower Clear Floor Space"
-
11B-202 Existing buildings and facilities
-
11B-411.4.1 Car dimensions
Inside dimensions of elevator cars and clear width of elevator doors shall comply with Section 11B-407.4.1....
-
R407.6.2 Width
The landing clear width shall be at least as wide as the widest ramp run leading to the landing....
-
11B-411.4.1 Car dimensions
Inside dimensions of elevator cars and clear width of elevator doors shall comply with Section 11B-407.4.1....
-
11B-411.4.1 Car dimensions
Inside dimensions of elevator cars and clear width of elevator doors shall comply with Section 11B-407.4.1....
-
405.7.2 Width
The landing clear width shall be at least as wide as the widest ramp run leading to the landing....
-
Initial Measures and Transfer Setup
The device seat to floor height was measured as the linear distance between the front of the seat, center-line point on top of the cushion (if present) and the floor (Figure 3 left). ...
-
M301.4.1 Clearance in Base (Section-by-Section Analysis)
The MDE NPRM proposed certain clearance requirements beneath the diagnostic equipment to allow sufficient space for the legs of a portable patient lift to fit underneath the equipment so...
-
DORMA BTS75V SERIES DOOR CLOSER
Floor-Concealed Door Closer The BTS75V Series of floor-concealed door closers offer adaptability to almost any installation....
-
4.34.6.4(3)
(3) Counter thickness and supporting structure shall be 2 in (50 mm) maximum over the required clear area....
-
Car Position Indicators [4.10.13]
Verbal announcements must announce each floor a car stops at but not each floor passed....
-
407.2.2.2 Visible Signals
Visible signal fixtures shall be centered at 72 inches (1830 mm) minimum above the finish floor or ground....
-
407.2.2.2 Visible Signals
Visible signal fixtures shall be centered at 72 inches (1830 mm) minimum above the finish floor or ground....
-
III-4.4400 Continuing obligation
If the hotel were newly constructed, it would be required to provide five fully accessible rooms (including one with a roll-in shower) and four rooms that are equipped with visual alarms...
-
Mannington Mills Against the Grain Collection Commercial Carpet
We make beautiful floors, with Mannington's well-known standards for quality built into every product. ...
-
High work surface
All of the seating spaces/work surfaces were approximately 42" high....
-
CCDA Accessibility Checklist for Building Inspectors, 2015 Edition
During construction inspection finish product thicknesses such as flooring materials or wall coverings must be considered when reviewing critical accessibility features, including but not...
-
Mannington Mills Boucle Collection Commercial Carpet
We make beautiful floors, with Mannington's well-known standards for quality built into every product. ...
-
11B-809.9.4 Work surfaces
Work surfaces shall be 36 inches (914 mm) maximum above the finish floor with minimum lengths at the following locations as required by this section: Linear length of 30 inches...
-
11B-809.10.8.1 Location
The top of the lavatory rim shall be 34 inches (864 mm) maximum above the finished floor....
-
11B-809.9.4 Work surfaces
Work surfaces shall be 36 inches (914 mm) maximum above the finish floor with minimum lengths at the following locations as required by this section: Linear length of 30 inches...
-
11B-809.10.8.1 Location
The top of the lavatory rim shall be 34 inches (864 mm) maximum above the finished floor....
-
Section 1630.1(a) Purpose
Section 1630.1(a) Purpose The express purposes of the ADA as amended are to provide a clear and comprehensive national mandate for the elimination of discrimination against individuals...
-
11B-405.7.2.1
Handrail extensions are not permitted to obstruct required clear landing dimensions except as allowed by the exception to Section 11B-307.2....
