(i) Provide a reasonable number of wheelchair seating spaces and seats with removable aisle-side arm rests; and...
Search Results "Access Aisle Width"
-
Sec.36.308(a)(1)(i)
-
M302.2.3 Transfer Sides
The transfer surface shall be located to provide options to transfer from a mobility device onto one short side (depth) and one long side (width) of the surface....
-
208.2.5.2
208.2.5.2 There must be one accessible parking space for each 150 metered on-street parking spaces provided by state agencies and political subdivisions....
-
11B-1003.3.1 Boat slip clearance
All other accessible slips are allowed to have the required pier clearance at the head of the slip....
-
1003.3.1 Boat Slip Clearance
All other accessible slips are allowed to have the required pier clearance at the head of the slip....
-
4 Appendix B to part 36: Analysis and Commentary on the 2010 ADA Standards for Accessible Design
Therefore, the Department will not restate here all of the comments and responses to them issued by the Access Board....
-
Q3.) What are the types of “manufacturing processes” that were anticipated where the advisory says “tolerances recognized by this provision include… “those that may be a necessary consequence of a particular manufacturing process”?
Therefore, the width at the back will be smaller than the width at the front. ...
- Whitehall Mfg. 4121ADA One-Station Compact Scrub Sink
- Whitehall Mfg. 4123ADA Three-Station Compact Scrub Sink
- Whitehall Mfg. 4122ADA Two-Station Compact Scrub Sink
-
36 CFR Part 1191 ADA and ABA Accessibility Guidelines for Emergency Transportable Housing Units
Compliance is not required by entities subject to the ADA until DOJ updates its accessibility standards to be consistent with the final rule. ...
- Mass Audubon's Accessible Trails Manual
-
4.2 Clear Floor Area
Clear Floor Area (Occupied) Width for All Devices Figures 12-13....
-
Required Compliance with the IBC [§207]
Required Compliance with the IBC [§207] Accessible means of egress must be provided according to the International Building Code (IBC)....
-
Chapter 9: Built-In Elements
provisions for benches concerning clear floor or ground space (903.2), back support (903.4), and height (903.5) addition of a requirement for check writing surfaces at check-out aisles...
-
36 CFR Part 1194 Electronic and Information Technology Accessibility Standards (Section 508 Standards)
36 CFR Part 1194 Electronic and Information Technology Accessibility Standards [Docket No. 2000–01] RIN 3014–AA25 AGENCY: Architectural and Transportation Barriers Compliance Board...
-
R308.1 Transit Stops
Where security bollards are installed at transit stops, they must not obstruct the clear space at boarding and alighting areas or reduce the required clear width at pedestrian access routes...
-
M301.2.3 Transfer Sides
The transfer surface shall be located to provide options to transfer from a mobility device onto one short side (depth) and one long side (width) of the surface....
-
382.51 What requirements must carriers meet concerning the accessibility of airport facilities?
382.51 What requirements must carriers meet concerning the accessibility of airport facilities?...
-
M302.4.1 Clearance in Base
Where the width of the examination surface is less than 36 inches (915 mm), the clearance depth shall extend the full width of the equipment....
-
M301.4.1 Clearance in Base
Where the width of examination surfaces is less than 36 inches (915 mm), the clearance depth shall extend the full width of the equipment....
-
M302.4.1 Clearance in Base
Where the width of the examination surface is less than 36 inches (915 mm), the clearance depth shall extend the full width of the equipment....
-
M301.4.1 Clearance in Base
Where the width of the examination surface is less than 36 inches (915 mm), the clearance depth shall extend the full width of the equipment....
-
11B-813.2.1.2 Clearance
A 36 inches minimum (914 mm) width side clearance shall be provided along the entire length of one side of adult changing tables....