A helpful video for individuals with disabilities who are traveling with a service animal to, from, or within the United States.
Search Results "Access Aisle Width"
Filters
Commonly Searched Documents
-
DOT: Traveling with Service Animals with Closed Captioning
-
407.4.1 Car Dimensions
Inside dimensions of elevator cars and clear width of elevator doors shall comply with Table 407.4.1....
-
Can handrails overlap ramp landings?
Along runs and landings, the minimum clear width must be measured between the leading edge of handrails....
-
11B-705.1.2.4 Bus stops
When detectable warnings are provided at bus stop boarding and alighting areas, the detectable warnings shall extend the full width of the boarding/alighting area and shall be 36 inches...
-
11B-607.5 Controls
Controls shall be between the bathtub rim and grab bar, and between the open side of the bathtub and the centerline of the width of the bathtub....
-
G.1. - Are there any exceptions to the requirement to acquire EIT that meets the technical provisions of the Access Board's standards?
Agencies are not required to acquire EIT that meets the technical provisions of the Access Board's standards if the acquisition: is for a national security system (FAR 39.204(b)...
-
E.5. - Will agencies have a way of obtaining standardized product testing results to determine if EIT meets the Access Board’s technical provisions?
In May 2001, the agencies with lead responsibilities for the implementation of Section 508 convened an Accessibility Forum to facilitate discussion among the EIT industry, disability advocacy...
-
Can a single EV charger service two EV Accessible spots or does each spot have to have its own charger?
RESPONSE: A single multiport EV charger that can simultaneously charge two vehicles can be used to serve two EV spaces required to be accessible....
-
1017.4 Passing Spaces
This section requires passing spaces to be provided at intervals of 1000 feet maximum where the clear tread width of trails is less than 60 inches....
-
11B-810.9 Escalators
Where provided, escalators shall comply with the sections 6.1.3.5.6 and 6.1.3.6.5 of ASME A17.1 and shall have a clear width of 32 inches (813 mm) minimum....
-
1017.10 Trailhead Signs
Typical and minimum tread width; 4. Typical and maximum running slope; and 5. Typical and maximum cross slope....
-
1002.4.7 Companion Seats
Where the interior width of the amusement ride is greater than 53 inches (1345 mm), seating is provided for more than one rider, and the wheelchair is not required to be centered within...
-
1002.4.7 Companion Seats
Where the interior width of the amusement ride is greater than 53 inches (1345 mm), seating is provided for more than one rider, and the wheelchair is not required to be centered within...
-
11B-1002.4.7 Companion seats
Where the interior width of the amusement ride is greater than 53 inches (1346 mm), seating is provided for more than one rider, and the wheelchair is not required to be centered within...
-
1017.10 Trailhead Signs
Typical and minimum tread width; 4. Typical and maximum running slope; and 5. Typical and maximum cross slope....
-
11B-810.9 Escalators
Where provided, escalators shall comply with the sections 6.1.3.5.6 and 6.1.3.6.5 of ASME A17.1 and shall have a clear width of 32 inches (813 mm) minimum....
-
§ 37.131(a)(1)(iv)
(iv) For purposes of this paragraph, the core service area is that area in which corridors with a width of three-fourths of a mile on each side of each fixed route merge together such that...
-
11B-1002.4.7 Companion seats
Where the interior width of the amusement ride is greater than 53 inches (1346 mm), seating is provided for more than one rider, and the wheelchair is not required to be centered within...
-
§ 38.57(c)
(c) The diameter or width of the gripping surface of handrails and stanchions shall be 11/4 inches to 11/2 inches or provide an equivalent gripping surface and shall provide a minimum 11...
-
11B-810.9 Escalators
Where provided, escalators shall comply with the sections 6.1.3.5.6 and 6.1.3.6.5 of ASME A17.1 and shall have a clear width of 32 inches (813 mm) minimum....
-
11B-1002.4.7 Companion seats
Where the interior width of the amusement ride is greater than 53 inches (1346 mm), seating is provided for more than one rider, and the wheelchair is not required to be centered within...
-
Wireless RERC: Accessibility, Usability, and the Design of Wearables and Wirelessly Connected Devices
As augmentative tools for work and living enhancement, and social participation, these technologies should be not only usable, but also be accessible and inclusive for people with disabilities...
-
1133B.2.3.2
SECTION 1133B GENERAL ACCESSIBILITY FOR ENTRANCES, EXITS AND PATHS OF TRAVEL 1133B.2 Doors. 1133B.2.3.2 Automatic and power-assisted doors. ...
-
D.2. - Must requiring officials consider all the Access Board’s technical provisions and functional performance criteria each time they purchase EIT?
Requiring officials need only consider all applicable technical provisions from the Access Board’s standards to ensure acquired products provide comparable access (see section B.2.ii, above...
