Where electric vehicle charging stations (EVCS) are provided, EVCS shall be provided in accordance with Section 11B-228.3....
Search Results "Non-Rail Vehicle"
Filters
Commonly Searched Documents
-
11B-228.3.1 General
-
206.4.4.2 Direct Connections
EXCEPTION: In key stations and existing intercity rail stations, existing direct connections shall not be required to comply with 404....
-
11B-206.4.4.2 Direct connections
Exception: In key stations and existing intercity rail stations, existing direct connections shall not be required to comply with Section 11B-404. ...
-
206.4.4.2 Direct Connections
EXCEPTION: In key stations and existing intercity rail stations, existing direct connections shall not be required to comply with 404....
-
11B-206.4.4.2 Direct connections
Exception: In key stations and existing intercity rail stations, existing direct connections shall not be required to comply with Section 11B-404....
-
11B-206.4.4.2 Direct connections
Exception: In key stations and existing intercity rail stations, existing direct connections shall not be required to comply with Section 11B-404....
-
§ 37.7(b)(2)(iv)
(iv) Alternative method of compliance, with demonstration of how the alternative meets or exceeds the level of accessibility or usability of the vehicle provided in part 38 of this subtitle...
-
§ 38.29(c)
(c) For vehicles in excess of 22 feet in length, overhead handrail(s) shall be provided which shall be continuous except for a gap at the rear doorway....
-
11B-228.3.1.1 Existing facilities
Where new EVCS are added to a facility with existing EVCS, the requirements of Section 11B-812 shall apply only to the new EVCS installed. Alterations to existing EVCS shall comply...
-
11B-812.5.1 Accessible route to building or facility
EVCS complying with Section 11B-812 that serve a particular building or facility shall be located on an accessible route to an entrance complying with Section 11B-206.4. Where EVCS...
-
§ 38.87(a)
(a) Each vehicle shall be equipped with an interior public address system permitting transportation system personnel, or recorded or digitized human speech messages, to announce stations...
-
If the manufacturer states that the design load is 800 pounds, can the transportation operator limit actual use to 600 pounds for safety reasons?
The National Highway Traffic Safety Administration’s (NHTSA) motor vehicle safety regulations require that a wheelchair lift be tested to withstand a 600-pound load....
-
11B-812.7.3 Lettering
The words “NO PARKING” shall be painted on the surface within each access aisle in letters a minimum of 12 inches (305 mm) in height and located to be visible from the adjacent...
-
11B-812.10.1 General
EV chargers shall comply with Section 11B-812.10.
-
11B-812.7.3 Lettering
The words “NO PARKING” shall be painted on the surface within each access aisle in letters a minimum of 12 inches (305 mm) in height and located to be visible from the adjacent...
-
11B-812.10.1 General
EV chargers shall comply with Section 11B-812.10.
-
§ 38.95(b)(9) Platform deflection
The lift platform (not including the entrance ramp) shall not deflect more than 3 degrees (exclusive of vehicle roll) in any direction between its unloaded position and its position when...
-
§ 38.31(b)
including doorways in which lifts or ramps are installed, shall have, at all times, at least 2 foot-candles of illumination measured on the step tread, or lift or ramp, when deployed at the vehicle...
-
11B-703.8.12 Protective covering
Where a protective layer is placed over VMS characters through which the VMS characters must be viewed, the protective covering shall have a non-glare finish....
-
11B-812.10.2 Operable parts
Operable parts and charging cord storage shall comply with Section 11B-309.
-
11B-812.10.2 Operable parts
Operable parts and charging cord storage shall comply with Section 11B-309.
-
11B-703.8.12 Protective covering
Where a protective layer is placed over VMS characters through which the VMS characters must be viewed, the protective covering shall have a non-glare finish....
-
11B-703.8.12 Protective covering
Where a protective layer is placed over VMS characters through which the VMS characters must be viewed, the protective covering shall have a non-glare finish....
-
11B-812.9 Surface marking
EVCS vehicle spaces shall provide surface marking stating “EV CHARGING ONLY” in letters 12 inches (305 mm) high minimum....