[See subsections ...]
Search Results "Non-Rail Vehicle"
Filters
Commonly Searched Documents
-
§ 37.107 Acquisition of passenger rail cars by private entities primarily engaged in the business of transporting people
-
Section 37.121 Requirement for Comparable Complementary Paratransit Service
This requirement applies to light and rapid rail systems as well as to bus systems, even when rail and bus systems share all or part of the same service area....
-
§ 38.23(b)(9) Platform deflection
The lift platform (not including the entrance ramp) shall not deflect more than 3 degrees (exclusive of vehicle roll or pitch) in any direction between its unloaded position and its position...
-
12148(b)(2) Historic trains
(2) Historic trains In order to comply with paragraph (1) with respect to the remanufacture of a vehicle of historic character which is to be used on a segment of a light or rapid rail...
-
F244.2.3.2.1 Recreational Vehicles
Where parking spaces are provided for recreational vehicles, at least one parking space shall comply with 1012.2, 1012.4, and 1012.5....
-
11B-812.4 Vertical clearance
Vehicle spaces, access aisles serving them, and vehicular routes serving them shall provide a vertical clearance of 98 inches (2489 mm) minimum....
-
11B-812.4 Vertical clearance
Vehicle spaces, access aisles serving them, and vehicular routes serving them shall provide a vertical clearance of 98 inches (2489 mm) minimum....
-
There is some confusion about whether the “accessible path” that is required means there must be an accessible path from the EVSE (charger) to the facility/building at which the station is installed, or whether the accessible path is just from the parking spot to the EVSE (charger). If the prior is enforced, it could increase the costs of installing EVSE in some instances. What is the correct interpretation of “accessible path”?
EVCS required by CBC Chapter 11B to be accessible must have both, an accessible route to the facility entrance (see CBC Section 11B-812.5.1) and an accessible route from the vehicle space...
-
3.1 Vehicle Parking
[See subsections ...]
-
§ 38.107(a)(1)
(1) The minimum clear floor area shall be 35 inches by 60 inches. Permanently installed fixtures may overlap this area a maximum of 6 inches, if the lowest portion of the fixture is...
-
The National Highway Traffic Safety Administration’s (NHTSA) motor vehicle safety regulations require that a wheelchair lift be tested to withstand a 600-pound load. If the manufacturer states that the design load is 800 pounds, can the transportation operator limit actual use to 600 pounds for safety reasons?
The 600-pound test required under NHTSA’s Federal Motor Vehicle Safety Standards (FMVSS) represents the minimum design load specified under 49 CFR Part 38....
-
III. Handrails and Stanchions
Handrails and Stanchions In addition to the requirements for handrails and stanchions for rapid, light, and commuter rail vehicles, consideration should be given to the proximity of handrails...
-
§ 38.91(c)(1)
(1) Commuter rail cars shall comply with §§38.93(d) and 38.109 of this part for level boarding unless structurally or operationally impracticable....
-
FTA Circular 4710.1: Americans with Disabilities Act Guidance
(Link is to PDF document online) November 4, 2015 Subject: AMERICANS WITH DISABILITIES ACT (ADA): GUIDANCE 1. PURPOSE. This circular provides guidance to recipients and...
-
3.1.1.3 Recreational Vehicle Parking Areas
Where recreational vehicle (RV) parking areas are provided at a camping facility or dump station, parking areas shall be provided for accessible RVs and trailers in accordance with Table...
-
CAL Green requires x number of EVSE per xxx number of spaces - each on its own 40 amp circuit. Some dual EVSE are on a single 40 amp circuit and split the 40 amp. Does this mean that half of those plugs don't comply with the required number?
RESPONSE: The California Green Code appears to require service panels, sub-panels, and raceway of sufficient capacity to accommodate 40 amp circuits rather than mandating one 40 amp...
-
§ 37.42(f)
Where the horizontal gap is more than 3 inches and/or the vertical gap is more than 5/8 inch, measured when the vehicle is at rest, the horizontal and vertical gaps between the car floor...
-
General: ADA Standard Section 218.1
Section 218.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for transportation facilities.
-
Transportation Facilities: ADA Standard Section 218
Section 218 covers scoping requirements in the current ADA Standards for transportation facilities.
-
11B-218.1 General
Transportation facilities shall comply with Section 11B-218.
-
11B-218 Transportation facilities
[See subsections ...]
-
11B-812.5.4 Arrangement
Vehicle spaces and access aisles shall be designed so that persons using them are not required to travel behind vehicle spaces or parking spaces other than the vehicle space in which their...
-
11B-812.5.4 Arrangement
Vehicle spaces and access aisles shall be designed so that persons using them are not required to travel behind vehicle spaces or parking spaces other than the vehicle space in which their...
-
§ 38.73(b) Signage
The International Symbol of Accessibility shall be displayed on the exterior of each vehicle operating on an accessible light rail system unless all vehicles are accessible and are not marked...
