The transfer surface shall be 30 inches (760 mm) wide minimum and 15 inches (381mm) deep minimum. Advisory M301.2.2 Size. The size requirements in this section apply only to the...
Search Results "Adjustable Height Counter"
-
M301.2.2 Size
-
M301.2 Transfer Surface
A transfer surface shall be provided and shall comply with M301.2.
-
M301.1 General
Where diagnostic equipment is used by patients in a supine, prone, or side-lying position, it shall comply with M301.
-
4.3.2 Transfer Surfaces and Imaging Equipment Functions
adjustable....
-
Adjustable height protocol
Adjustable height protocol: From initial setup, only the height of the platform was adjusted incrementally: higher (Figure 3) and lower than the subject’s seat. ...
-
Can parking signage height be considered a "safe harbor"?
Recommendation: Since traffic codes often govern sign height, ADAAG does not specify a height for parking signs....
-
Height
The Access Board is considering whether 6 inches minimum and 19 inches maximum above the transfer surface would be an appropriate height for transfer supports on diagnostic equipment used...
-
Height: ADA Standard Section 1009.5.3
The height of the transfer platform shall comply with 1009.4.2....
-
Height: ADA Standard Section 704.4.1
Advisory 704.4.1 Height....
-
602.4 Spout Height
Spout outlets shall be 36 inches (915 mm) maximum above the finish floor or ground.
-
4.15.2* Spout Height
Spouts shall be no higher than 36 in (915 mm), measured from the floor or ground surfaces to the spout outlet (see Fig. 27(a)).
-
4.15.2* SPOUT HEIGHT
Spouts shall be no higher than 36 in (915 mm), measured from the floor or ground surfaces to the spout outlet (see Fig. 27(a)). Figure 27 Drinking Fountains and Water...
-
602.4 Spout Height
Spout outlets shall be 36 inches (915 mm) maximum above the finish floor or ground.
-
Midmark 625 Barrier-Free® Power Examination Table
Features include: Power height and back 650-pound patient weight capacity 18-inch to 37-inch seat height adjustment Unique Quick Exam® and Motion Profiling™ control features...
-
F231.4 Visiting Areas
Visiting areas shall comply with F231.4.
-
11B-231.4 Visiting areas
Visiting areas shall comply with 11B-231.4.
-
1133A.4.1 Exceptions
Exceptions: Stone, cultured stone and tiled countertops may be used without meeting the repositioning requirements. Two 15-inch (381 mm) wide minimum breadboards may...
-
1133A.4, Item 1
1. A minimum linear length of 30 inches (762 mm) of countertop shall be provided for the kitchen sink installation.
-
7.3(3)
(3) Signage identifying accessible check-out aisles shall comply with 4.30.7 and shall be mounted above the check-out aisle in the same location where the check-out number or type of...
-
4.7.2 Slope
Slopes of curb ramps shall comply with 4.8.2. The slope shall be measured as shown in Fig. 11. Transitions from ramps to walks, gutters, or streets shall be flush and free of abrupt...
-
4.7.2 SLOPE
Slopes of curb ramps shall comply with 4.8.2. The slope shall be measured as shown in Fig. 11. Transitions from ramps to walks, gutters, or streets shall be flush and free of abrupt...
-
11B-231.4 Visiting areas
Visiting areas shall comply with 11B-231.4.
-
1133A.4, Item 1
1. A minimum linear length of 30 inches (762 mm) of countertop shall be provided for the kitchen sink installation.
