1-11/16” Narrow Mullion Push Plate Switch – Recessed, Surface Box or Bollard Mount....
Search Results "Hybrid Surface System"
Commonly Searched Documents
- SDC Push Plate Switch
- LEAD Center
- DOT: Accessible Transportation Technologies Research Initiative (ATTRI)
- United Nations Disability Statistics
- Willoughby Industries 2230 Series AquaDeck Lavatory Deck
- Willoughby Industries 2240 AquaDeck Lavatory Deck Angled Front
-
III. Summary of Comments
Survey,3 including equipment characteristics that affect patients ability to access and use medical equipment, such as: dimensions of the equipment (e.g. height, width, length,) contact surfaces...
-
B. The ADA Standards for Accessible Design
Section 904.2 requires that “[a]ll portions of counters required to comply with 904 shall be located adjacent to a walking surface complying with 403.” 2010 Standards § 904.2....
-
C. Raised Porches Are Part Of the Store That Must Be Made Accessible and Located On An Accessible Route
Pursuant to Chapter 3, accessible spaces must have compliant floor surfaces, compliant turning space, and compliant clear floor space, among other requirements. 2010 Standards, §§ 301-309...
-
1. Executive Summary
access routes to be provided within pedestrian circulation paths located in the public right-of-way, and would establish proposed technical provisions for the width, grade, cross slope, and surface...
-
2. Electronic (Digital) Level
Note: Some architects use a "rise over run" formula to calculate the slope of a surface....
-
11B-1003.3.2 Boarding pier clearances
At high water, the entire chain is floating and a transition plate connects the first float to the surface of the launch ramp....
-
1003.3.2 Boarding Pier Clearances
At high water, the entire chain is floating and a transition plate connects the first float to the surface of the launch ramp....
-
Value Contrast (slide 9)
Fixed Surfaces To show where vertical and horizontal surfaces meet is very important. To show edges is very important....
-
1003.3.2 Boarding Pier Clearances
At high water, the entire chain is floating and a transition plate connects the first float to the surface of the launch ramp....
-
Telescopes and Periscopes
Whenever a telescope or periscope is provided, ensure that a separate telescope or periscope is available for use from a standing position (60 inches above the floor or ground surface is...
-
Trail Slopes
Cross slopes—the side-to-side slope of a trail tread (figure 131)—provide drainage to keep water from ponding and damaging the trail, especially on unpaved surfaces....
- Midmark 630 HUMANFORM™ Procedures Table
- Tormax Technologies iMotion® TN 110 In-Floor Swing Door Operator (High and Low Energy)
-
308.3.2 Obstructed High Reach
Operable parts of fuel dispensers shall be permitted to be 54 inches (1370 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
106.5.45 Primary Function
a primary function include, but are not limited to: (i) Remodeling merchandise display areas or employee work areas in a department store; (ii) Replacing an inaccessible floor surface...
-
G. Sleeping Areas
Accessible cots have a sleeping surface at approximately the same height above the floor as the seat of a wheelchair (17 to 19 inches above the floor)....
-
308.3.2 Obstructed High Reach
Operable parts of fuel dispensers shall be permitted to be 54 inches (1370 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
F216.13 Trailhead Signs
The technical requirements in 1017.11 require the signs to include information on the length of the trail or trail segment; surface type; typical and minimum tread width; typical and minimum...