When the lift is at car floor height with the inner barrier down (if applicable) or retracted, gaps between the forward lift platform edge and car floor shall not exceed 1/2 inch horizontally...
Search Results "Horizontal Projection"
Commonly Searched Documents
-
§ 38.95(b)(7) Platform gaps
-
§ 38.125(b)(7) Platform gaps
When the lift is at car floor height with the inner barrier (if applicable) down or retracted, gaps between the forward lift platform edge and car floor shall not exceed 1/2 inch horizontally...
-
11B-1008.3.2.3 Transfer supports
Some examples of supports include a rope loop, a loop type handle, a slot in the edge of a flat horizontal or vertical member, poles or bars, or D rings on the corner posts. ◼...
- Wooster Products NITEGLOW® Anti-Slip Glow-In-The-Dark Safety Products
-
Grab bar clearance
Have local authorities accepted one-piece dispensers in toilet compartments that are recessed behind the horizontal grab bars? These units stick out ¼" or so....
-
5.3.1 Permitted Obstructions to Transfer Sides for M301 and M302
NPRM Preamble Discussion: The Access Board is considering whether the final standards should permit equipment parts to extend horizontally 3 inches maximum beyond the edge of the transfer...
-
1.1
DSA review and approval is not required for alteration or reconstruction projects to school buildings governed by the Field Act with an estimated construction cost of $103,300, or less,...
-
4.1.3(3) COMMON AREAS
At least one of each type of common area and amenity in each project shall be accessible and shall be located on an accessible route to any accessible dwelling unit....
-
Exception 5
Alterations of existing parking lots by resurfacing and/or restriping shall be limited to the actual scope of work of the project and shall not be required to comply with Section 11B-202.4...
-
Compilation of Instruments and Measurement Methods for Surface Accessibility
Compilation of Instruments and Measurement Methods for Surface Accessibility During the course of this project the following information was developed as background information to assist...
-
Introduction
When recreation professionals understand what is needed, accessibility becomes integrated into the thinking, planning, designing, construction, and maintenance of every project from the...
-
SHOPPING CENTER (OR SHOPPING MALL)
on a common site, connected by a common pedestrian access route on, above or below the ground floor, that is either under common ownership or common control or developed either as one project...
-
Shopping Center or Shopping Mall
building housing five or more sales or rental establishments; or (2) A series of buildings on a common site, either under common ownership or common control or developed either as one project...
-
6.1 Required Elements for Accessible Parking
at school facilities shall be considered accessible when the following elements are provided in compliance with the CBC edition in effect at the time of the installation of a solar PV project...
-
Background
Background: When PV systems are proposed for installation at public school sites, the project documentation is first reviewed from a scoping perspective to determine the required accessibility...
-
106.5.60 Shopping Center or Shopping Mall
A building housing five or more sales or rental establishments; or a series of buildings on a common site, either under common ownership or common control or developed either as one project...
-
Preface
Anthropology Research Project, Inc....
- Diaper Deck Infant Changing Table
-
505.10.2 Top Extension at Stairs
At the top of a stair flight, handrails shall extend horizontally above the landing for 12 inches (305 mm) minimum beginning directly above the first riser nosing....
-
f-v
If a ramp is more than 30 feet long, is a level landing at least 60 inches long provided at every 30 feet of horizontal length?...
-
4d.
If a ramp is more than 30 feet long, is a level landing at least 60 inches long provided every 30 feet of horizontal length?...
-
6d. Ramp Length
If a ramp is more than 30 feet long, is a level landing at least 60 inches long provided every 30 feet of horizontal length?...
-
11B-809.10.5.2 Reinforcement for grab bars
Grab bar backing shall be installed horizontally to permit the installation of a 48-inch (1219 mm) grab bar with each end 6 inches (152 mm) maximum from the end walls of the bathtub....
-
Roadway resurfacing, curb ramps at crosswalks
If roadways are being resurfaced or otherwise altered as part of a BRT project, curb ramps must be installed at crosswalks that have been affected. (DOT ADA Standard 106.5.)...